p0879 transmission fluid pressure sensor switch d circuit intermittent 2

P0879 Transmission Fluid Pressure Sensor Switch D Circuit Intermittent 2

Definition: The OBD-II code P0879 indicates that the Powertrain Control Module (PCM) has detected an intermittent issue with the transmission fluid pressure sensor/switch D circuit. This means there is an inconsistent signal from the sensor, which monitors the hydraulic pressure in the transmission.

p0879 – Transmission Fluid Pressure Sensor/Switch D Circuit Intermittent 2

Typical Severity: Moderate

Common Causes

P0879 – Transmission Fluid Pressure Sensor/Switch D Circuit Intermittent 2

Common Causes:

  • Low transmission fluid level
  • Dirty or contaminated transmission fluid
  • Faulty transmission fluid pressure sensor/switch
  • Wiring issues such as loose connections or shorts
  • Faulty transmission control module (TCM)

 

Common Misdiagnosis

OBD2 Code: P0879

Description: Transmission Fluid Pressure Sensor/Switch D Circuit Intermittent

Common Misdiagnosis: Replacing the transmission fluid pressure sensor/switch without checking for wiring issues or connector problems.

 

Common Diagnostic Steps

OBD2 Code: P0879

Description: Transmission Fluid Pressure Sensor/Switch D Circuit Intermittent

  • Check the transmission fluid level and condition. Ensure it is at the correct level and not contaminated.
  • Inspect the wiring and connectors for damage, corrosion, or loose connections in the circuit related to the transmission fluid pressure sensor/switch D.
  • Test the transmission fluid pressure sensor/switch D using a multimeter to ensure it is functioning within specifications.
  • Examine the vehicle’s PCM (Powertrain Control Module) for any additional codes that may indicate other issues affecting this circuit.
  • If necessary, replace the transmission fluid pressure sensor/switch D if found faulty after testing.
  • Clear all codes and perform a test drive to see if the code returns, ensuring proper repair has been made.

Leave a Comment

You must be logged in to post a comment.