U1133 – Lost Communication with Vehicle Dynamics Control Module.

The ODBII code U1133 indicates a loss of communication with the Vehicle Dynamics Control Module, which may affect the vehicle’s stability and traction control systems.

The severity of ODBII code U1133 is generally considered moderate to high.

Common Causes For: U1132 SCP (J1850) Invalid or Missing Data for Vehicle Motion

• Faulty Vehicle Dynamics Control Module (VDCM)
• Damaged wiring or connectors
• Poor ground connections
• Corroded or loose connectors
• Malfunctioning CAN bus communication
• Software issues or firmware corruption
• Faulty power supply to the VDCM
• Other related module failures

Common misdiagnosis for U1133 Lost Communication with Vehicle Dynamics Control Module.

• Faulty ABS module
• Wiring issues or shorts
• Bad wheel speed sensors
• Faulty engine control module (ECM)
• Incorrectly diagnosed transmission issues
• Power supply problems
• Faulty body control module (BCM)
• Software or firmware issues in the control modules

Common Troubleshooting Steps

When dealing with the OBD-II code U1133, which indicates “Lost Communication with Vehicle Dynamics Control Module,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, multiple codes can provide more context about the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the Vehicle Dynamics Control Module (VDCM) for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent or corroded.
• Check Power and Ground: **Power Supply: Verify that the VDCM is receiving the correct voltage. Use a multimeter to check the power supply to the module.
• **Ground Connection: Ensure that the ground connection for the VDCM is secure and functioning properly.
• Inspect the Vehicle Dynamics Control Module: **Module Condition: Check the VDCM for any physical damage or signs of failure.
• **Reprogramming: If applicable, consider reprogramming or updating the software of the VDCM.
• Check for Communication Issues: **CAN Bus Integrity: Inspect the Controller Area Network (CAN) bus for any faults. Use a scan tool to monitor the communication between modules.
• **Other Modules: Ensure that other modules on the CAN bus are functioning correctly, as a failure in one module can affect communication with others.
• Perform a Hard Reset: Disconnect the vehicle’s battery for a few minutes to reset the modules. Reconnect and see if the code reappears.
• Test the VDCM: If you have access to a diagnostic tool that can communicate with the VDCM, perform a communication test to see if the module responds.
• Check for Environmental Factors: Ensure that there are no environmental factors (like moisture or extreme temperatures) affecting the VDCM or its connections.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of your vehicle that might address known issues with the VDCM.
• Seek Professional Help: If the issue persists after performing the above steps, it may be necessary to consult a professional mechanic or technician who has experience with your vehicle’s specific systems.Conclusion Troubleshooting OBD-II code U1133 involves a systematic approach to check for communication issues, inspect wiring and connections, and ensure that the VDCM is functioning properly. Always refer to the vehicle’s service manual for specific procedures and specifications related to your vehicle.