U1194 – SCP (J1850) Invalid or Missing Data for Mirrors

The ODBII code U1194 SCP (J1850) Invalid or Missing Data for Mirrors indicates a communication issue within the vehicle’s network, specifically related to the data exchange for the mirror control system.

The severity of ODBII code U1194 SCP (J1850) Invalid or Missing Data for Mirrors is generally considered moderate.

Common Causes For: U1193 U1193: “Module Communication Failure”

• Faulty mirror control module
• Damaged wiring or connectors
• Poor ground connection
• Malfunctioning body control module (BCM)
• Corroded or loose electrical connections
• Software issues or programming errors
• Faulty mirror sensors or actuators
• Interference from aftermarket accessories

Common misdiagnosis for U1194 SCP (J1850) Invalid or Missing Data for Mirrors

• Faulty mirror control module
• Wiring issues or shorts in the mirror circuit
• Malfunctioning body control module (BCM)
• Corrupted software or firmware in the vehicle’s network
• Issues with the vehicle’s data bus communication
• Faulty or damaged mirrors themselves
• Poor ground connections related to the mirror system

Common Troubleshooting Steps

When dealing with OBD-II code U1194, which indicates “SCP (J1850) Invalid or Missing Data for Mirrors,” there are several common troubleshooting steps you can take to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the mirrors for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent or corroded.
• Test the Mirror Functions: Manually test the mirror adjustments and heating functions (if applicable) to see if they operate correctly. If they do not, the issue may be with the mirrors themselves.
• Check the SCP (J1850) Communication: **Network Integrity: Ensure that the SCP (J1850) communication network is functioning properly. This may involve checking other modules on the network to see if they are communicating correctly.
• **Scan Tool: Use a scan tool to monitor the data bus for any irregularities or communication failures.
• Inspect the Body Control Module (BCM): The BCM often controls the mirrors. Check for any faults in the BCM and ensure it is receiving power and ground.
• If possible, reprogram or reset the BCM to see if that resolves the issue.
• Check for Software Updates: Sometimes, manufacturers release software updates for the vehicle’s modules. Check if there are any updates available for the BCM or other related modules.
• Perform a Hard Reset: Disconnect the vehicle’s battery for a few minutes to reset the modules. Reconnect and see if the code reappears.
• Inspect for Water Damage: Check for any signs of water intrusion in the area where the mirror connectors are located, as moisture can cause communication issues.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U1194 code or mirror issues for your specific vehicle make and model. Manufacturers may have documented common fixes.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose the problem more effectively.Conclusion By following these troubleshooting steps, you can systematically identify and address the cause of the U1194 code. Always ensure safety precautions are taken when working on vehicle electrical systems.