U1226 – SCP (J1850) Invalid or Missing Data for Body Status Request

The ODBII code U1226 SCP (J1850) indicates that there is invalid or missing data related to a body status request, typically involving communication issues between the vehicle’s modules over the SCP (Serial Communication Protocol) network.

The severity of ODBII code U1226 is typically considered moderate.

Common Causes For: U1225 SCP (J1850) Invalid or Missing Data for Primary Id

• Faulty Body Control Module (BCM)
• Communication issues in the data bus
• Damaged wiring or connectors
• Corrupted software or firmware in the BCM
• Malfunctioning sensors or actuators
• Low battery voltage or power supply issues
• Intermittent electrical connections
• Aftermarket modifications or installations affecting communication

Common misdiagnosis for U1226 SCP (J1850) Invalid or Missing Data for Body Status Request

• Faulty Body Control Module (BCM)
• Wiring issues or short circuits
• Faulty communication network (CAN bus issues)
• Defective sensors related to body functions
• Software or firmware issues in the BCM
• Incorrectly configured aftermarket accessories
• Low battery voltage or power supply issues

Common Troubleshooting Steps

When dealing with OBD-II code U1226, which indicates “Invalid or Missing Data for Body Status Request” on the SCP (J1850) communication network, there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Addressing related codes can help in diagnosing the root cause.
• Inspect the Wiring and Connectors: **Visual Inspection: Check the wiring and connectors associated with the body control module (BCM) and other related modules for signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or pushed back.
• Test the Body Control Module (BCM): **Functionality: Verify that the BCM is functioning correctly. This may involve checking for proper operation of body-related functions (e.g., lights, locks, etc.).
• **Power and Ground: Ensure that the BCM is receiving proper power and ground. Use a multimeter to check voltage and ground continuity.
• Check Communication Lines: **Network Communication: Use a scan tool to monitor the communication on the SCP (J1850) bus. Look for any irregularities or interruptions in communication between modules.
• **Bus Termination: Ensure that the bus is properly terminated. Check for the presence of termination resistors at both ends of the communication line.
• Inspect Other Modules: **Interconnected Modules: Check other modules that communicate with the BCM. If another module is malfunctioning, it may affect the data being sent to the BCM.
• **Module Updates: Ensure that all modules have the latest software updates, as manufacturers may release updates to fix communication issues.
• Perform a Hard Reset: Disconnect the vehicle’s battery for a few minutes to reset the modules. Reconnect and see if the code reappears.
• Check for Environmental Factors: **Moisture and Corrosion: Inspect for moisture intrusion or corrosion in connectors and wiring, especially in areas prone to water exposure.
• **Temperature Effects: Consider if the issue occurs under specific temperature conditions, which may indicate a failing component.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have documented common issues and fixes for this code.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized diagnostic tools and experience with the specific vehicle.Conclusion By following these troubleshooting steps, you can systematically identify and address the cause of the U1226 code. Always ensure safety precautions are taken when working on vehicle electrical systems.