U1239 – SCP (J1850) Invalid or Missing Data for Experimental #4

The ODBII code U1239 indicates that there is invalid or missing data related to the SCP (Serial Communication Protocol) for Experimental #4, which typically suggests a communication issue between modules in the vehicle’s network.

The severity of ODBII code U1239 is moderate.

Common Causes For: U1238 U1238: “Module Communication Failure”

• Faulty communication between modules
• Damaged or corroded wiring or connectors
• Malfunctioning or incompatible aftermarket devices
• Software or firmware issues in the control modules
• Low battery voltage or poor power supply
• Interference from other electronic devices
• Faulty or failing control module
• Incorrectly configured or programmed vehicle settings

Common misdiagnosis for U1239 SCP (J1850) Invalid or Missing Data for Experimental #4

• Faulty OBDII connector
• Damaged wiring or connectors
• Malfunctioning PCM (Powertrain Control Module)
• Incorrectly configured aftermarket devices
• Faulty sensors (e.g., speed, temperature)
• Software issues or glitches in the vehicle’s computer system
• Issues with the vehicle’s communication network (CAN bus)
• Low battery voltage or electrical system problems

Common Troubleshooting Steps

When dealing with OBD-II code U1239, which indicates “SCP (J1850) Invalid or Missing Data for Experimental #4,” you can follow these common troubleshooting steps:

• Check for Additional Codes: Start by scanning the vehicle’s OBD-II system for any additional trouble codes. Sometimes, multiple codes can provide more context for the issue.
• Inspect the Wiring and Connectors: Examine the wiring and connectors associated with the SCP (Serial Communication Protocol) bus. Look for signs of damage, corrosion, or loose connections that could affect communication.
• Verify Battery Voltage: Ensure that the vehicle’s battery is fully charged and that the voltage is within the normal range (typically 12.4 to 12.6 volts). Low voltage can cause communication issues.
• Check Ground Connections: Inspect the ground connections for the modules involved in the SCP communication. Poor ground connections can lead to communication failures.
• Test the SCP Bus: Use a scan tool or oscilloscope to monitor the SCP bus for proper communication. Check for voltage levels and signal integrity. If the signals are not as expected, there may be a fault in the bus or the modules communicating over it.
• Inspect Modules: Identify the modules that communicate over the SCP bus. Check for any signs of failure or malfunction in these modules. If a specific module is suspected, it may need to be tested or replaced.
• Check for Software Updates: Sometimes, software issues can cause communication problems. Check with the manufacturer for any available software updates for the vehicle’s modules.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U1239 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues that could help in diagnosing the problem.
• Professional Diagnosis: If the issue persists after performing these steps, consider seeking help from a professional technician who has experience with OBD-II systems and the specific vehicle in question. By following these steps, you should be able to identify and resolve the issue related to the U1239 code.