U1250 – refers to a communication error between modules in the vehicle’s network.

The ODBII code U1250 indicates a communication error between modules in the vehicle’s network, typically signifying that one or more control modules are not able to communicate properly with each other.

The severity of ODBII code U1250 is moderate.

Common Causes For: U1249 U1249: BECM Communication Failure

• Faulty wiring or connectors
• Malfunctioning control module
• Corroded or damaged terminals
• Poor ground connections
• Intermittent electrical issues
• Software glitches or outdated firmware
• Faulty CAN bus communication
• Low battery voltage or weak battery
• Aftermarket modifications or installations
• Environmental factors (moisture, heat) affecting connections

Common misdiagnosis for U1250 refers to a communication error between modules in the vehicle’s network.

• Faulty ECM (Engine Control Module)
• Bad wiring or connectors
• Defective sensors
• Malfunctioning body control module (BCM)
• Issues with the powertrain control module (PCM)
• Battery or charging system problems
• Corrupted software or firmware in modules
• Faulty CAN bus communication lines
• Grounding issues
• Intermittent electrical connections

Common Troubleshooting Steps

When dealing with OBD-II code U1250, which indicates a communication error between modules in the vehicle’s network, there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context about the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Look for damaged, frayed, or corroded wiring and connectors related to the affected modules.
• **Connector Security: Ensure that all connectors are securely attached and free of corrosion.
• Check the Modules: **Module Functionality: Verify that the modules involved in the communication are functioning properly. This may involve checking for power and ground at the module connectors.
• **Module Compatibility: Ensure that all modules are compatible with each other and that there are no aftermarket modules that could be causing communication issues.
• Test the Communication Network: **CAN Bus Testing: If your vehicle uses a CAN (Controller Area Network) bus, use a multimeter or oscilloscope to check for proper voltage levels and signal integrity on the bus lines.
• **Network Resistance: Measure the resistance of the CAN bus to ensure it is within specifications (typically around 60 ohms).
• Check for Short Circuits or Open Circuits: Use a multimeter to check for shorts to ground or open circuits in the wiring harnesses associated with the communication lines.
• Inspect for Interference: Look for any aftermarket devices or modifications that may be interfering with the vehicle’s communication network.
• Clear Codes and Test Drive: After performing inspections and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Update or Reprogram Modules: If the issue persists, check if any of the modules require a software update or reprogramming. This may need to be done at a dealership or a qualified repair facility.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U1250 code for your specific vehicle make and model. Manufacturers may have specific fixes or recommendations for this code.
• Seek Professional Help: If you are unable to resolve the issue after following these steps, it may be necessary to consult a professional mechanic or technician who specializes in automotive electronics. By following these steps, you can systematically diagnose and address the communication error indicated by the U1250 code.