FixItFor.Us
C code chassis High severity

C1245 ABS Outlet Valve Coil LR Circuit Short To Ground

The OBD2 code C1245 indicates a short circuit to ground in the left rear (LR) outlet valve coil circuit of the ABS (Anti-lock Braking System), which can affect the operation of the ABS system

Definition

The OBD2 code C1245 indicates a short circuit to ground in the left rear (LR) outlet valve coil circuit of the ABS (Anti-lock Braking System), which can affect the operation of the ABS system

Common causes

  • Damaged wiring or connectors
  • Short circuit in the ABS outlet valve coil circuit
  • Faulty ABS outlet valve coil
  • Corroded or loose electrical connections
  • Water intrusion or moisture in the connector
  • Faulty ABS control module

Common misdiagnoses

  • Faulty ABS module
  • Damaged wiring or connectors
  • Faulty wheel speed sensor
  • Incorrectly installed or defective brake components
  • Faulty relay or fuse
  • Grounding issues in the ABS system
  • Faulty brake pedal position sensor

Troubleshooting steps

  1. 1. Visual Inspection

    Wiring and Connectors: Inspect the wiring harness and connectors associated with the ABS outlet valve coil for any signs of damage, fraying, or corrosion. Pay special attention to the left rear wheel area

  2. 2. ABS Module

    Check the ABS control module for any visible damage or loose connections

  3. 3. Check for Additional Codes

    Use an OBD-II scanner to check for any other related trouble codes. This can provide more context and help identify if there are other issues present

  4. 4. Test the ABS Outlet Valve Coil

    Resistance Check: Disconnect the connector from the ABS outlet valve coil and use a multimeter to measure the resistance of the coil. Compare the reading to the manufacturer's specifications. If the resistance is too low (indicating a short) or too high (indicating an open circuit), the coil may need to be replaced

  5. 5. Power and Ground Check

    With the connector still disconnected, check for power and ground at the connector terminals while the ignition is on. This will help determine if the circuit is functioning correctly

  6. 6. Inspect Ground Connections

    Ensure that all ground connections related to the ABS system are clean, tight, and free of corrosion. A poor ground can cause various electrical issues

  7. 7. Check for Shorts in the Wiring

    Use a multimeter to check for continuity between the ABS outlet valve coil circuit and ground. If you find continuity where there shouldn't be any, there may be a short in the wiring

  8. 8. Inspect the wiring harness for any signs of pinching, rubbing, or contact with hot surfaces that could cause a short

  9. 9. Test the ABS Control Module

    If the wiring and components appear to be in good condition, the ABS control module itself may be faulty. Testing or replacing the module may be necessary if all other components check out

  10. 10. Clear Codes and Test Drive

    After performing repairs or replacements, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns

  11. 11. Consult Repair Manual

    If the issue persists, consult the vehicle's repair manual for specific diagnostic procedures and specifications related to the ABS system

  12. 12. Seek Professional Help

    If you are unable to resolve the issue after following these steps, it may be best to consult a professional mechanic or an automotive technician with experience in ABS systems. By following these steps, you should be able to diagnose and potentially resolve the issue related to the C1245 code