FixItFor.Us
P code powertrain High severity

P0935 Hydraulic Pressure Sensor Circuit High Input

The OBD2 code P0935 indicates that the hydraulic pressure sensor circuit is experiencing a high input signal, which may suggest a malfunction in the sensor or its wiring, leading to incorrect pressure readings in the...

Definition

The OBD2 code P0935 indicates that the hydraulic pressure sensor circuit is experiencing a high input signal, which may suggest a malfunction in the sensor or its wiring, leading to incorrect pressure readings in the transmission system

Common causes

  • Faulty hydraulic pressure sensor
  • Wiring issues (short circuit or open circuit)
  • Poor electrical connections
  • Faulty transmission control module (TCM)
  • Low transmission fluid level
  • Contaminated transmission fluid
  • Internal transmission failure

Common misdiagnoses

  • Transmission fluid issues
  • Faulty transmission control module (TCM)
  • Wiring or connector problems
  • Faulty hydraulic pressure sensor
  • Transmission solenoid issues
  • Incorrect transmission fluid type
  • Mechanical transmission problems

Troubleshooting steps

  1. 1. Check for Additional Codes

    Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context and help identify related issues

  2. 2. Inspect Wiring and Connectors

  3. 3. Visually inspect the wiring and connectors associated with the hydraulic pressure sensor. Look for signs of damage, corrosion, or loose connections

  4. 4. Ensure that the wiring is not pinched, frayed, or exposed to heat sources

  5. 5. Test the Hydraulic Pressure Sensor

  6. 6. Use a multimeter to test the resistance and voltage output of the hydraulic pressure sensor. Compare the readings to the specifications provided in the vehicle’s service manual

  7. 7. If the sensor is out of specification, it may need to be replaced

  8. 8. Check for Fluid Leaks

    Inspect the transmission fluid level and condition. Low fluid levels or contaminated fluid can affect hydraulic pressure readings. If necessary, top off or replace the transmission fluid

  9. 9. Inspect the Transmission Control Module (TCM)

  10. 10. Check for any software updates or reprogramming that may be required for the TCM

  11. 11. Ensure that the TCM is functioning properly and that there are no internal faults

  12. 12. Test the Circuit

  13. 13. Use a multimeter to check the voltage and ground at the sensor connector. Ensure that the sensor is receiving the correct voltage and that the ground is solid

  14. 14. If the voltage is too high, there may be a short circuit or a fault in the wiring

  15. 15. Check for Mechanical Issues

  16. 16. Inspect the transmission for any mechanical issues that could affect hydraulic pressure, such as a failing pump or internal leaks

  17. 17. If necessary, perform a pressure test on the transmission to ensure it is operating within specifications

  18. 18. Clear Codes and Test Drive

    After performing repairs or replacements, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns

  19. 19. Consult a Professional

    If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with transmission systems and can perform more advanced diagnostics. By following these steps, you should be able to identify and resolve the issue associated with the P0935 code