WOMS
P code powertrain High severity

P273E Transmission Fluid Pressure Sensor Range/Performance Problem

The OBD2 code P273E indicates that the transmission fluid pressure sensor is experiencing a range or performance issue, meaning it is not providing accurate readings or is outside the expected operational parameters

Definition

The OBD2 code P273E indicates that the transmission fluid pressure sensor is experiencing a range or performance issue, meaning it is not providing accurate readings or is outside the expected operational parameters

Common causes

  • Faulty transmission fluid pressure sensor
  • Wiring issues or damaged connectors
  • Low transmission fluid level
  • Contaminated or degraded transmission fluid
  • Faulty transmission control module (TCM)
  • Internal transmission problems
  • Poor electrical connections
  • Software issues or updates needed in the TCM

Common misdiagnoses

  • Transmission fluid level issues
  • Faulty transmission fluid temperature sensor
  • Transmission control module (TCM) failure
  • Wiring or connector issues
  • Faulty transmission solenoids
  • Internal transmission problems
  • Engine control module (ECM) issues
  • Incorrect transmission fluid type or condition

Troubleshooting steps

  1. 1. Check for Additional Codes

    Use an OBD-II scanner to check for any other related trouble codes. This can provide more context and help identify if there are other issues affecting the transmission

  2. 2. Inspect the Transmission Fluid

    Fluid Level: Check the transmission fluid level. Low fluid can cause pressure issues

  3. 3. Fluid Condition

    Inspect the fluid for contamination, burning smell, or unusual color. If the fluid is dirty or burnt, consider a fluid change

  4. 4. Fluid Type

    Ensure the correct type of transmission fluid is being used as specified by the manufacturer

  5. 5. Examine the Transmission Fluid Pressure Sensor

    Visual Inspection: Check the sensor and its wiring for any signs of damage, corrosion, or loose connections

  6. 6. Connector Check

    Ensure that the electrical connector is secure and free of dirt or moisture

  7. 7. Test the Transmission Fluid Pressure Sensor

    Use a multimeter to test the sensor’s resistance and voltage output according to the manufacturer’s specifications. Compare the readings to the expected values

  8. 8. If the sensor is faulty, it may need to be replaced

  9. 9. Inspect Wiring and Connectors

    Look for damaged wiring or poor connections in the circuit leading to the transmission fluid pressure sensor. Repair or replace any damaged components

  10. 10. Check for Mechanical Issues

    Inspect the transmission for any mechanical problems that could affect fluid pressure, such as a stuck valve or internal leaks

  11. 11. If applicable, check the transmission solenoids and ensure they are functioning correctly

  12. 12. Perform a Transmission Fluid Pressure Test

    If you have the necessary tools, perform a pressure test to verify that the transmission is generating the correct fluid pressure under various operating conditions

  13. 13. Clear Codes and Test Drive

    After addressing any issues found, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns

  14. 14. Consult Technical Service Bulletins (TSBs)

    Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common issues related to the P273E code

  15. 15. Seek Professional Help

    If the problem persists after performing these steps, it may be necessary to consult a professional mechanic or transmission specialist for further diagnosis.Conclusion By following these troubleshooting steps, you can systematically identify and address the underlying issues causing the P273E code. Always refer to the vehicle’s service manual for specific procedures and specifications related to your particular model