WOMS
P code powertrain Medium severity

P28E7 Transmission Control Module (TCM) Performance

The OBD2 code P28E7 indicates a performance issue with the Transmission Control Module (TCM), suggesting that the TCM is not operating within its expected parameters or is experiencing a malfunction

Definition

The OBD2 code P28E7 indicates a performance issue with the Transmission Control Module (TCM), suggesting that the TCM is not operating within its expected parameters or is experiencing a malfunction

Common causes

  • Faulty Transmission Control Module (TCM)
  • Wiring issues or damaged connectors
  • Low transmission fluid levels
  • Contaminated or degraded transmission fluid
  • Faulty transmission sensors (e.g., speed sensors)
  • Software issues or outdated TCM programming
  • Mechanical transmission problems
  • Electrical issues, such as short circuits or open circuits in the TCM circuit

Common misdiagnoses

  • Faulty Transmission Control Module (TCM)
  • Wiring issues or short circuits
  • Faulty sensors (e.g., speed sensors)
  • Low transmission fluid levels
  • Transmission fluid contamination
  • Mechanical transmission issues
  • Engine control module (ECM) problems
  • Incorrectly calibrated transmission
  • Software issues or outdated firmware
  • Electrical connector problems

Troubleshooting steps

  1. 1. Check for Additional Codes

    Use an OBD-II scanner to check for any other related trouble codes. Sometimes, multiple codes can provide more context about the issue

  2. 2. Inspect Wiring and Connectors

    Examine the wiring and connectors related to the TCM for any signs of damage, corrosion, or loose connections. Pay special attention to the harness that connects to the TCM

  3. 3. Check TCM Power and Ground

    Ensure that the TCM is receiving proper power and ground. Use a multimeter to check the voltage at the TCM connector. Refer to the vehicle's service manual for the correct voltage specifications

  4. 4. Inspect Transmission Fluid

    Check the transmission fluid level and condition. Low or dirty fluid can cause performance issues. If the fluid is low, top it off with the correct type of fluid. If it’s dirty, consider a transmission fluid change

  5. 5. Test the TCM

    If the wiring and connections are good, the next step is to test the TCM itself. This may involve using specialized diagnostic equipment or software to check the TCM's functionality

  6. 6. Check for Software Updates

    Sometimes, manufacturers release software updates for the TCM. Check with the dealership or manufacturer to see if there are any updates available for your vehicle's TCM

  7. 7. Inspect Transmission Components

    If the TCM is functioning properly, inspect other transmission components such as solenoids, sensors, and the valve body for any issues that could affect performance

  8. 8. Perform a Reset

    After addressing any issues found, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns

  9. 9. Consult Technical Service Bulletins (TSBs)

    Check for any TSBs related to the P28E7 code for your specific vehicle make and model. Manufacturers may have documented common issues and fixes

  10. 10. Seek Professional Help

    If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or transmission specialist for further diagnosis. By following these steps, you can systematically identify and address the cause of the P28E7 code