WOMS
U code network High severity

U0112 Lost Communication With Battery Energy Control Module "B

The OBD2 code U0112 indicates a loss of communication with the Battery Energy Control Module "B," which may affect the vehicle's hybrid or electric power management system

Definition

The OBD2 code U0112 indicates a loss of communication with the Battery Energy Control Module "B," which may affect the vehicle's hybrid or electric power management system

Common causes

  • Faulty Battery Energy Control Module (BECM)
  • Damaged wiring or connectors
  • Corroded terminals
  • Poor ground connections
  • Faulty communication network (CAN bus issues)
  • Low battery voltage
  • Software issues or glitches
  • Malfunctioning powertrain control module (PCM)

Common misdiagnoses

  • Faulty Battery Energy Control Module (BECM)
  • Wiring issues or damaged connectors
  • Faulty Engine Control Module (ECM)
  • Battery issues or low voltage
  • Faulty communication network (CAN bus issues)
  • Corroded terminals or poor ground connections
  • Faulty alternator or charging system problems
  • Software or firmware issues in the control modules

Troubleshooting steps

  1. 1. Check for Other Codes

    Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or indicate related issues

  2. 2. Inspect the Wiring and Connectors

    Visual Inspection: Check the wiring harness and connectors related to the Battery Energy Control Module (BECM) for any signs of damage, corrosion, or loose connections

  3. 3. Connector Pins

    Ensure that the pins in the connectors are not bent, corroded, or damaged

  4. 4. Check the Battery and Charging System

    Battery Voltage: Ensure the battery is fully charged and in good condition. A weak battery can cause communication issues

  5. 5. Charging System

    Verify that the alternator is functioning properly and that the charging system is working as intended

  6. 6. Inspect the BECM

    Module Condition: Check the Battery Energy Control Module for any signs of physical damage or water intrusion

  7. 7. Reprogramming

    If applicable, consider reprogramming or updating the BECM software, as software issues can sometimes lead to communication problems

  8. 8. Check for Ground Issues

    Ensure that all ground connections related to the BECM and the vehicle’s electrical system are secure and free of corrosion

  9. 9. Test Communication Lines

    Use a multimeter or an oscilloscope to test the communication lines (CAN bus) for continuity and proper voltage levels

  10. 10. Check for short circuits or open circuits in the communication lines

  11. 11. Scan Tool Communication

    Use a professional scan tool to attempt to communicate with the BECM directly. If communication is not possible, it may indicate a problem with the module itself

  12. 12. Check for Intermittent Issues

    Sometimes, communication issues can be intermittent. Monitor the vehicle for any patterns or specific conditions under which the code appears

  13. 13. Consult Technical Service Bulletins (TSBs)

    Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common issues related to the BECM

  14. 14. Replace the BECM (if necessary)

    If all other troubleshooting steps fail and the BECM is determined to be faulty, consider replacing the module. Ensure that the replacement module is compatible with the vehicle.1

  15. 15. Clear Codes and Test Drive

    After performing repairs or replacements, clear the trouble codes and take the vehicle for a test drive to see if the code returns.Conclusion If you are not comfortable performing these troubleshooting steps or if the issue persists after your attempts, it may be best to consult a professional mechanic or technician who has experience with your specific vehicle make and model. They will have the tools and expertise to diagnose and repair the issue effectively