WOMS
U code network High severity

U1661 Lost Communication with Body Control Module (BCM)

The OBD2 code U1661 indicates that there is a loss of communication between the vehicle's control module and the Body Control Module (BCM), which may affect various electrical functions and systems

Definition

The OBD2 code U1661 indicates that there is a loss of communication between the vehicle's control module and the Body Control Module (BCM), which may affect various electrical functions and systems

Common causes

  • Faulty Body Control Module (BCM)
  • Damaged wiring or connectors
  • Poor ground connection
  • Corroded terminals
  • Faulty communication network (CAN bus)
  • Blown fuses
  • Software issues or programming errors
  • Intermittent electrical issues

Common misdiagnoses

  • Faulty Body Control Module (BCM)
  • Wiring issues or damaged connectors
  • Faulty Instrument Cluster
  • Malfunctioning Powertrain Control Module (PCM)
  • Battery or charging system problems
  • Faulty fuses
  • Communication network issues (CAN bus problems)
  • Grounding issues
  • Faulty sensors or actuators
  • Software or firmware issues in the BCM or other modules

Troubleshooting steps

  1. 1. Check for Additional Codes

    Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context and help identify related issues

  2. 2. Inspect Wiring and Connectors

    Visual Inspection: Check the wiring harness and connectors leading to the BCM for any signs of damage, corrosion, or loose connections

  3. 3. Connector Pins

    Ensure that the pins in the connectors are not bent, corroded, or pushed back

  4. 4. Check Power and Ground

    Power Supply: Verify that the BCM is receiving the correct voltage. Use a multimeter to check the power supply at the BCM connector

  5. 5. Ground Connections

    Ensure that the ground connections for the BCM are secure and free of corrosion

  6. 6. Inspect the BCM

    Physical Condition: Check the BCM for any signs of physical damage or water intrusion

  7. 7. Reprogramming

    If the BCM has been replaced, ensure that it has been properly programmed to the vehicle

  8. 8. Test Communication Lines

    CAN Bus Communication: Use a scan tool to check if the BCM is communicating with other modules on the CAN bus. If other modules are also not communicating, the issue may be with the bus itself

  9. 9. Scope Testing

    If available, use an oscilloscope to check the CAN bus signals for proper voltage levels and signal integrity

  10. 10. Check for Short Circuits

    Inspect the wiring for any short circuits to ground or power that could affect communication with the BCM

  11. 11. Look for Environmental Factors

    Consider if there have been any recent changes to the vehicle, such as aftermarket installations, that could affect the BCM or its communication

  12. 12. Reset the System

    Clear the trouble codes using the OBD-II scanner and see if the code returns. Sometimes, a temporary glitch can cause communication issues

  13. 13. Consult Technical Service Bulletins (TSBs)

    Check for any TSBs related to the specific make and model of the vehicle that may address known issues with the BCM or communication problems

  14. 14. Replace the BCM (if necessary)

    If all other troubleshooting steps fail and the BCM is determined to be faulty, consider replacing it. Ensure proper programming and configuration after replacement.1

  15. 15. Seek Professional Help

    If you are unable to resolve the issue, it may be best to consult a professional mechanic or dealership with experience in diagnosing and repairing BCM-related issues. By following these steps, you should be able to identify the root cause of the U1661 code and take appropriate action to resolve the communication issue with the Body Control Module