FixItFor.Us
U codenetworkMedium severity

U1759U1759: "Module Communication Failure

The OBD2 code U1759 indicates a "Module Communication Failure," meaning there is a problem with communication between the vehicle's control modules, which may affect their ability to exchange data properly

Definition

The OBD2 code U1759 indicates a "Module Communication Failure," meaning there is a problem with communication between the vehicle's control modules, which may affect their ability to exchange data properly

Common causes

  • Faulty wiring or connectors
  • Failed or malfunctioning module
  • Poor ground connections
  • Communication network issues (CAN bus problems)
  • Corroded or damaged terminals
  • Software or firmware issues
  • Intermittent electrical connections
  • Low battery voltage or power supply issues

Common misdiagnoses

  • Faulty wiring or connectors
  • Defective control module
  • Software issues or updates needed
  • Battery or power supply problems
  • Grounding issues
  • Intermittent communication issues
  • Other communication protocol failures

Troubleshooting steps

  1. 1.Check for Other Codes

    Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue

  2. 2.Inspect Wiring and Connectors

  3. 3.Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections

  4. 4.Pay special attention to the ground connections, as poor grounding can lead to communication issues

  5. 5.Check Power Supply

  6. 6.Ensure that the affected modules are receiving the proper voltage. Use a multimeter to check the power supply to the modules

  7. 7.Look for blown fuses that may affect the power supply to the modules

  8. 8.Test Communication Lines

  9. 9.Use a scan tool to check the communication lines (CAN bus, LIN bus, etc.) for continuity and proper voltage levels

  10. 10.If you have access to an oscilloscope, you can check the signal waveforms on the communication lines to ensure they are functioning correctly

  11. 11.Inspect Modules

  12. 12.If possible, check the affected module for any signs of damage or malfunction. This may involve removing the module and inspecting it physically

  13. 13.If you suspect a module is faulty, you may need to replace it or reprogram it

  14. 14.Perform a Network Test

  15. 15.Some advanced scan tools can perform a network test to identify communication issues between modules. This can help pinpoint which module is causing the problem

  16. 16.Reset the Codes

  17. 17.After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns

  18. 18.Consult Technical Service Bulletins (TSBs)

  19. 19.Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common communication issues

  20. 20.Seek Professional Help

  21. 21.If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with automotive electronics and communication systems. By following these steps, you should be able to identify and resolve the underlying cause of the U1759 code