WOMS
U code network Medium severity

U1920 U1920: "Module Communication Failure

The OBD2 code U1920 indicates a "Module Communication Failure," meaning there is a problem with communication between vehicle modules, often due to a fault in the wiring, connectors, or the modules themselves

Definition

The OBD2 code U1920 indicates a "Module Communication Failure," meaning there is a problem with communication between vehicle modules, often due to a fault in the wiring, connectors, or the modules themselves

Common causes

  • Faulty wiring or connectors
  • Failed or malfunctioning control module
  • Poor ground connections
  • Corroded or damaged pins in connectors
  • Intermittent communication issues
  • Software or firmware issues in modules
  • Low battery voltage or power supply issues
  • Electrical interference or noise
  • Incorrectly configured or incompatible modules
  • Faulty CAN bus communication lines

Common misdiagnoses

  • Faulty wiring or connectors
  • Defective control module
  • Software issues or updates needed
  • Battery or power supply problems
  • Grounding issues
  • Intermittent communication issues
  • Other communication protocol failures
  • Sensor malfunctions

Troubleshooting steps

  1. 1. Check for Other Codes

    Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue

  2. 2. Inspect Wiring and Connectors

  3. 3. Visually inspect the wiring and connectors associated with the affected module(s). Look for signs of damage, corrosion, or loose connections

  4. 4. Pay special attention to the ground connections, as poor grounding can lead to communication issues

  5. 5. Check Power Supply

    Ensure that the affected module is receiving the proper voltage. Use a multimeter to check the power and ground circuits

  6. 6. Test the Module

    If possible, test the affected module to see if it is functioning correctly. This may involve using specialized diagnostic tools or swapping the module with a known good one

  7. 7. Check for Intermittent Issues

    Sometimes, communication failures can be intermittent. Try to replicate the conditions under which the code was set, and monitor the vehicle's performance

  8. 8. Inspect the CAN Bus

    If the vehicle uses a Controller Area Network (CAN) bus for communication, check for issues on the bus

  9. 9. Look for short circuits or open circuits in the CAN wiring

  10. 10. Use an oscilloscope to check the CAN signals for proper voltage levels and waveforms

  11. 11. Update Software/Firmware

    Check if there are any software or firmware updates available for the vehicle's modules. Sometimes, communication issues can be resolved with an update

  12. 12. Clear Codes and Test Drive

    After performing any repairs or inspections, clear the trouble codes and take the vehicle for a test drive to see if the code returns

  13. 13. Seek Professional Help

    If the issue persists after performing the above steps, it may be necessary to consult a professional mechanic or technician who has experience with the specific make and model of the vehicle. By following these steps, you can systematically diagnose and address the communication failure indicated by the U1920 code