WOMS
U code network High severity

U2308 Lost Communication with the Body Control Module (BCM)"

The OBD2 code U2308 indicates that there is a communication failure between the vehicle's control module and the Body Control Module (BCM), which may affect various electrical functions and systems in the vehicle

Definition

The OBD2 code U2308 indicates that there is a communication failure between the vehicle's control module and the Body Control Module (BCM), which may affect various electrical functions and systems in the vehicle

Common causes

  • Faulty Body Control Module (BCM)
  • Damaged wiring or connectors
  • Corroded terminals
  • Blown fuses
  • Poor ground connections
  • Malfunctioning communication network (CAN bus issues)
  • Software or firmware issues in the BCM
  • Other module failures affecting communication

Common misdiagnoses

  • Faulty Body Control Module (BCM)
  • Wiring issues or shorts in the communication lines
  • Faulty or corroded connectors
  • Issues with the power supply to the BCM
  • Problems with other control modules
  • Software or firmware issues in the BCM
  • Faulty ignition switch
  • Battery or charging system problems

Troubleshooting steps

  1. 1. Check for Other Codes

    Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or indicate related issues

  2. 2. Inspect the Wiring and Connectors

    Visual Inspection: Check the wiring harness and connectors leading to the BCM for any signs of damage, corrosion, or loose connections

  3. 3. Connector Pins

    Ensure that the pins in the connectors are not bent, corroded, or pushed back

  4. 4. Check Power and Ground

    Power Supply: Verify that the BCM is receiving the correct voltage. Use a multimeter to check the power supply at the BCM connector

  5. 5. Ground Connections

    Ensure that the ground connections for the BCM are secure and free of corrosion

  6. 6. Inspect the BCM

    Physical Condition: Check the BCM for any signs of physical damage, such as cracks or burn marks

  7. 7. Reprogramming

    If the BCM has been replaced, ensure that it has been properly programmed to the vehicle

  8. 8. Test Communication Lines

    CAN Bus: Use a scan tool to check the communication on the CAN bus. If other modules are not communicating, there may be a fault in the bus itself

  9. 9. Scope Testing

    If available, use an oscilloscope to check for proper signal patterns on the communication lines

  10. 10. Check for Short Circuits

    Inspect the wiring for any short circuits to ground or power that could affect communication with the BCM

  11. 11. Look for Environmental Factors

    Check for moisture or water intrusion in the BCM area, which can cause communication issues

  12. 12. Perform a Hard Reset

    Disconnect the battery for a few minutes to reset the vehicle’s electronic systems. Reconnect and see if the code returns

  13. 13. Consult Technical Service Bulletins (TSBs)

    Look for any TSBs related to the specific make and model of the vehicle that may address known issues with the BCM or communication problems

  14. 14. Replace the BCM (if necessary)

    If all other steps have been exhausted and the BCM is determined to be faulty, consider replacing it. Ensure proper programming and configuration after replacement.1

  15. 15. Seek Professional Help

    If you are unable to resolve the issue, it may be best to consult a professional mechanic or dealership with experience in diagnosing and repairing BCM-related issues.Conclusion Always remember to take safety precautions when working on a vehicle's electrical system. If you are not comfortable performing these steps, it is advisable to seek professional assistance