WOMS
U code network Medium severity

U2613 Lost Communication with the Steering Angle Sensor

The OBD2 code U2613 indicates a loss of communication between the vehicle's control module and the steering angle sensor, which may affect the vehicle's stability control and steering functions

Definition

The OBD2 code U2613 indicates a loss of communication between the vehicle's control module and the steering angle sensor, which may affect the vehicle's stability control and steering functions

Common causes

  • Faulty steering angle sensor
  • Damaged wiring or connectors
  • Poor electrical connections
  • Malfunctioning power supply to the sensor
  • Software issues or calibration errors
  • Faulty vehicle control module (VCM)
  • Interference from other electronic components

Common misdiagnoses

  • Faulty steering angle sensor
  • Wiring issues or damaged connectors
  • Faulty steering column module
  • Malfunctioning ABS module
  • Incorrectly calibrated steering angle sensor
  • Power supply issues
  • Faulty vehicle stability control system
  • Software or firmware issues in the vehicle's control modules

Troubleshooting steps

  1. 1. Check for Other Codes

    Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context or indicate related issues

  2. 2. Inspect Wiring and Connectors

    Visual Inspection: Check the wiring harness and connectors associated with the steering angle sensor for any signs of damage, corrosion, or loose connections

  3. 3. Connector Pins

    Ensure that the pins in the connectors are not bent, corroded, or pushed back

  4. 4. Test the Steering Angle Sensor

    Sensor Functionality: If possible, test the steering angle sensor using a multimeter or scan tool to ensure it is functioning correctly. Check for proper voltage and signal output

  5. 5. Calibration

    Some vehicles require the steering angle sensor to be calibrated after installation or repair. Refer to the vehicle’s service manual for calibration procedures

  6. 6. Check Power and Ground

    Power Supply: Verify that the steering angle sensor is receiving the correct voltage. Use a multimeter to check the power supply at the sensor connector

  7. 7. Ground Connection

    Ensure that the ground connection for the sensor is intact and has a good connection

  8. 8. Inspect the CAN Bus

    Communication Lines: Since the steering angle sensor communicates over the CAN bus, check for any issues with the CAN wiring. Look for shorts, opens, or interference

  9. 9. CAN Bus Termination

    Ensure that the CAN bus is properly terminated at both ends

  10. 10. Check for Software Issues

    ECU Updates: Sometimes, software updates for the vehicle’s ECU can resolve communication issues. Check with the manufacturer for any available updates

  11. 11. Resetting the ECU

    Disconnect the battery for a few minutes to reset the ECU, then reconnect and see if the code returns

  12. 12. Test Other Related Components

    If the steering angle sensor is part of a larger system (like stability control or power steering), check other components in that system for faults

  13. 13. Consult Technical Service Bulletins (TSBs)

    Look for any TSBs related to the steering angle sensor or communication issues for your specific vehicle make and model. Manufacturers may have known fixes for common problems

  14. 14. Professional Diagnosis

    If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose the problem more effectively.Conclusion By following these troubleshooting steps, you can systematically identify and address the cause of the U2613 code. Always refer to the specific service manual for your vehicle for detailed procedures and specifications