B1317 – Battery Voltage High
The ODBII code B1317 indicates that the vehicle’s battery voltage is higher than the normal operating range, which may suggest an issue with the charging system or battery.
The severity of ODBII code B1317 Battery Voltage High is moderate.
Common Causes For: B1316 Battery Saver Relay Coil Circuit Short To Ground
- Faulty battery
- Faulty alternator
- Poor electrical connections
- Corroded battery terminals
- Voltage regulator issues
- Shorted wiring
- Malfunctioning power distribution module
- Incorrectly installed aftermarket accessories
Common misdiagnosis for B1317 Battery Voltage High
- Faulty battery
- Bad alternator
- Corroded battery terminals
- Faulty voltage regulator
- Wiring issues or shorts
- Faulty engine control module (ECM)
- Incorrectly calibrated sensors
- Faulty ground connections
Common Troubleshooting Steps
The OBD-II code B1317 indicates a “Battery Voltage High” condition, which typically means that the vehicle’s battery voltage is higher than the normal operating range. This can be caused by various issues, including problems with the battery, alternator, or electrical system. Here are some common troubleshooting steps to diagnose and resolve the issue:
- Check Battery Voltage:: Use a multimeter to measure the battery voltage. A healthy, fully charged battery should read around 12.6 volts when the engine is off and between 13.7 to 14.7 volts when the engine is running (indicating the alternator is charging the battery).
- Inspect Battery Condition:: Check for any signs of corrosion on the battery terminals and clean them if necessary.
- Inspect the battery for any physical damage, swelling, or leaks. If the battery is old or damaged, consider replacing it.
- Examine the Alternator:: Test the alternator output. If the alternator is overcharging, it can cause high voltage readings. A faulty voltage regulator can also lead to this issue.
- Check the alternator connections and wiring for any signs of damage or loose connections.
- Inspect Electrical Connections:: Look for any loose or corroded connections in the electrical system, especially around the battery and alternator.
- Ensure that all ground connections are secure and free of corrosion.
- Check for Parasitic Draw:: If the vehicle has electrical components that are drawing excessive current when the vehicle is off, it can lead to battery voltage issues. Use a multimeter to check for parasitic draw.
- Scan for Additional Codes:: Use an OBD-II scanner to check for any other trouble codes that may be present. Other codes can provide additional context for the issue.
- Inspect the Charging System:: Check the entire charging system, including the wiring harness, fuses, and relays associated with the battery and alternator.
- Reset the Code:: After addressing any issues found, clear the code using an OBD-II scanner and take the vehicle for a test drive to see if the code returns.
- Consult a Professional:: If the issue persists after performing these checks, it may be best to consult a professional mechanic for further diagnosis and repair. By following these steps, you should be able to identify and resolve the cause of the B1317 code. Always ensure safety precautions are taken when working with the vehicle’s electrical system.