B1458 – Wiper Washer Pump Motor Relay Circuit Failure

The ODBII code B1458 indicates a failure in the wiper washer pump motor relay circuit, suggesting an issue with the relay or its associated wiring, which may prevent the washer pump from functioning properly.

The severity of ODBII code B1458 is generally considered low.

Common Causes For: B1457 Wiper Washer Fluid Lamp Circuit Short To Ground

• Faulty wiper washer pump motor
• Defective relay
• Damaged wiring or connectors
• Blown fuse
• Corrosion in the electrical connections
• Short circuit in the circuit
• Faulty body control module (BCM)

Common misdiagnosis for B1458 Wiper Washer Pump Motor Relay Circuit Failure

• Faulty wiper washer pump
• Bad wiper switch
• Damaged wiring or connectors
• Blown fuse
• Faulty body control module (BCM)
• Incorrectly installed or malfunctioning relay
• Low washer fluid level sensor issue

Common Troubleshooting Steps

When dealing with OBD-II code B1458, which indicates a “Wiper Washer Pump Motor Relay Circuit Failure,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check the Vehicle’s Manual: Refer to the vehicle’s service manual for specific information regarding the wiper washer pump motor relay circuit, including wiring diagrams and component locations.
• Visual Inspection: Inspect the wiper washer pump motor and relay for any visible damage, corrosion, or loose connections.
• Check the wiring harness for frays, breaks, or shorts.
• Test the Wiper Washer Pump Motor: Disconnect the pump motor and apply direct battery voltage to see if the motor operates. If it does not work, the pump may be faulty and needs replacement.
• Check the Relay: Locate the wiper washer pump relay and test it. You can do this by swapping it with a similar relay in the fuse box (if applicable) or using a multimeter to check for continuity.
• If the relay is faulty, replace it.
• Inspect the Fuse: Check the fuse associated with the wiper washer pump circuit. If the fuse is blown, replace it and see if the issue persists.
• Test the Circuit: Use a multimeter to check for voltage at the relay and the pump motor when the washer switch is activated. Ensure that the circuit is receiving power.
• Check for ground continuity at the pump motor and relay.
• Check the Washer Switch: The issue may also stem from a faulty washer switch. Test the switch for proper operation and continuity when activated.
• Scan for Additional Codes: Use an OBD-II scanner to check for any additional trouble codes that may provide more context or indicate related issues.
• Inspect the Body Control Module (BCM): If all other components check out, the problem may lie within the BCM, which controls the relay operation. Testing or reprogramming the BCM may be necessary.
• Consult a Professional: If you are unable to resolve the issue after these steps, it may be best to consult a professional mechanic or technician who can perform more advanced diagnostics.Conclusion By following these troubleshooting steps, you should be able to identify the cause of the B1458 code and take appropriate action to fix the wiper washer pump motor relay circuit failure. Always ensure safety precautions are taken when working on electrical components.