B1538 – Memory 2 Switch Circuit Short To Ground

The ODBII code B1538 indicates a fault in the memory 2 switch circuit, specifically that there is a short to ground, which means the circuit is unintentionally connected to the vehicle’s ground, causing improper function.

The severity of ODBII code B1538 is moderate.

Common Causes For: B1537 Memory 2 Switch Circuit Short To Battery

• Shorted wiring or connectors in the switch circuit.
• Faulty switch or component in the circuit.
• Damaged insulation on wires causing a ground short.
• Corroded or loose connections in the circuit.
• Malfunctioning control module.

Common misdiagnosis for B1538 Memory 2 Switch Circuit Short To Ground

• Faulty body control module (BCM)
• Defective switch or button
• Wiring harness issues
• Shorted wiring or connectors
• Faulty relay
• Incorrectly installed aftermarket accessories
• Grounding issues in the electrical system
• Corroded connectors or terminals

Common Troubleshooting Steps

The OBD-II code B1538 indicates a problem with the memory 2 switch circuit, specifically a short to ground. This code is often associated with issues in the vehicle’s power seat or memory seat system. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Visual Inspection: **Wiring and Connectors: Check the wiring harness and connectors related to the memory seat switch for any signs of damage, fraying, or corrosion. Pay special attention to areas where the wiring may be exposed to heat or moisture.
• **Switch Condition: Inspect the memory switch itself for any physical damage or signs of wear.
• Check for Short Circuits: **Multimeter Testing: Use a multimeter to check for continuity in the memory switch circuit. Disconnect the switch and measure resistance between the switch terminals and ground. A low resistance reading indicates a short to ground.
• **Inspect Ground Points: Ensure that all ground connections related to the memory seat system are secure and free of corrosion.
• Scan Tool Diagnosis: **Clear Codes: Use an OBD-II scanner to clear the code and see if it returns. Sometimes, a temporary glitch can cause a code to set.
• **Live Data Monitoring: If available, monitor live data from the memory seat system to see if the switch is functioning correctly when activated.
• Test the Memory Switch: **Switch Functionality: Test the memory switch for proper operation. If the switch is faulty, it may need to be replaced.
• **Bench Test: If possible, remove the switch and perform a bench test to ensure it operates correctly outside of the vehicle.
• Inspect Related Components: **Memory Module: Check the memory module (if equipped) for faults. This module controls the memory functions of the seat and may be the source of the issue.
• **Power Supply: Ensure that the power supply to the memory switch is functioning correctly. Check fuses and relays associated with the memory seat system.
• Repair or Replace Faulty Components: Based on your findings, repair any damaged wiring or connectors. Replace any faulty switches or modules as necessary.
• Recheck for Codes: After making repairs, reconnect everything and clear the codes again. Test the system to ensure that the issue has been resolved and that the code does not return.
• Consult Service Manual: If the problem persists, consult the vehicle’s service manual for specific diagnostic procedures related to the memory seat system and the B1538 code.
• Professional Help: If you are unable to resolve the issue after following these steps, consider seeking assistance from a professional mechanic or automotive technician who has experience with electrical systems. By following these troubleshooting steps, you should be able to identify and resolve the issue related to the B1538 code.