P0010 Intake Camshaft Position Actuator Circuit Open Bank 1

Definition: The P0010 code indicates that the Engine Control Module (ECM) has detected a malfunction in the variable valve timing (VVT) circuit for bank 1. This could be due to an open or shorted circuit, poor electrical connection, or a faulty VVT solenoid.

p0010 – Intake Camshaft Position Actuator Circuit Open Bank 1

Typical Severity: Moderate

Common Causes

P0010 – Intake Camshaft Position Actuator Circuit Open Bank 1

Common causes:

• Faulty camshaft position actuator solenoid
• Open or short in the wiring harness
• Poor electrical connection at the camshaft position actuator solenoid
• Low engine oil level or dirty engine oil

 

Common Misdiagnosis

OBD2 Code: P0010

Description: Intake Camshaft Position Actuator Circuit Open Bank 1

Common Misdiagnosis: Replacing the camshaft position sensor without checking the wiring or actuator itself.

 

Common Diagnostic Steps

OBD2 Code: P0010

Description: Intake Camshaft Position Actuator Circuit Open Bank 1

• Check the engine oil level and condition. Ensure it is at the correct level and not contaminated.
• Inspect the wiring and connectors to the intake camshaft position actuator for damage or corrosion.
• Test the voltage supply to the camshaft position actuator using a multimeter.
• Verify that there is no blockage in the oil passages leading to the camshaft phaser.
• Use an OBD2 scanner to clear the code, then perform a test drive to see if it returns.
• If equipped, check for any related Technical Service Bulletins (TSBs) from the manufacturer.
• If all else fails, consider replacing the intake camshaft position actuator solenoid on bank 1.