U1339 – Manufacturer Specific code, which typically indicates a communication issue between modules in the vehicle’s network.

The ODBII code U1339 indicates a communication issue between modules in the vehicle’s network, often related to a fault in the data bus or a specific module not responding properly.

The severity of ODBII code U1339 is generally considered moderate to severe, as it indicates a communication issue that can affect multiple systems in the vehicle.

Common Causes For: U1338 U1338: “Control Module Communication Failure”

• Faulty wiring or connectors
• Malfunctioning control module
• Corroded or damaged pins
• Poor ground connections
• Intermittent electrical issues
• Software glitches or outdated firmware
• Faulty CAN bus communication
• Short circuits in the wiring harness
• Electrical interference from aftermarket devices
• Low battery voltage or weak battery

Common misdiagnosis for U1339 Manufacturer Specific” code, which typically indicates a communication issue between modules in the vehicle’s network.

• Faulty wiring or connectors
• Defective control module
• Low battery voltage
• Corroded terminals
• Intermittent electrical issues
• Software glitches or outdated firmware
• Incorrectly installed aftermarket accessories
• Grounding issues
• Faulty sensors
• Communication protocol errors

Common Troubleshooting Steps

The OBD-II code U1339 is a manufacturer-specific code that typically indicates a communication issue between modules in the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication issues.
• Check Module Functionality:
• Identify the specific module(s) that are having communication issues. This may require consulting the vehicle’s service manual or wiring diagrams.
• If possible, test the functionality of the affected module(s) to ensure they are operating correctly.
• Perform a Network Scan:
• Use a professional-grade scan tool to perform a network scan. This can help identify which modules are not communicating properly.
• Some scan tools can also provide live data, which can help in diagnosing the issue.
• Inspect the CAN Bus:
• If the vehicle uses a Controller Area Network (CAN) bus, check for proper voltage levels on the CAN lines. The typical voltage should be around 2.5V when the network is idle.
• Look for short circuits or open circuits in the CAN wiring.
• Check for Software Updates:
• Sometimes, communication issues can be resolved with a software update for the affected modules. Check with the manufacturer for any available updates.
• Reset the Modules:
• Disconnect the battery for a few minutes to reset the vehicle’s modules. Reconnect the battery and see if the code returns.
• Some vehicles may require a specific procedure to reset modules, so consult the service manual.
• Test with a Different Scan Tool:
• If you suspect the scan tool may not be reading correctly, try using a different OBD-II scanner to see if the same codes appear.
• Consult Technical Service Bulletins (TSBs):
• Check for any TSBs related to the U1339 code for your specific vehicle make and model. Manufacturers often release TSBs for known issues and their fixes.
• Professional Diagnosis:
• If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have access to specialized diagnostic tools and resources. By following these steps, you can systematically diagnose and potentially resolve the communication issue indicated by the U1339 code.