U1351 – Manufacturer Specific code, which typically indicates a communication issue between modules in the vehicle’s network.

The ODBII code U1351 indicates a communication issue between modules in the vehicle’s network, often related to a failure in data transmission or a malfunction in one of the control modules.

The severity of ODBII code U1351 is generally considered moderate to severe, as it indicates a communication issue that can affect multiple systems in the vehicle.

Common Causes For: U1348 U1348: “Control Module Communication Failure”

• Faulty wiring or connectors
• Malfunctioning control module
• Corrupted software or firmware
• Poor ground connections
• Intermittent electrical issues
• Short circuits in the communication lines
• Incompatible or aftermarket modules
• Low battery voltage or weak battery
• Faulty CAN bus system
• Environmental factors (moisture, corrosion)

Common misdiagnosis for U1351 Manufacturer Specific” code, which typically indicates a communication issue between modules in the vehicle’s network.

• Faulty wiring or connectors
• Defective control module
• Low battery voltage
• Corrupted software or firmware
• Intermittent electrical issues
• Incorrectly installed aftermarket accessories
• Grounding issues
• Faulty sensors
• Communication network interference
• Other unrelated module failures

Common Troubleshooting Steps

The OBD-II code U1351 is a manufacturer-specific code that generally indicates a communication issue between modules in a vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Addressing other codes may resolve the U1351 code.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring and connectors related to the modules involved in the communication network. Look for signs of damage, corrosion, or loose connections.
• **Repair or Replace: Repair any damaged wires or connectors and ensure all connections are secure.
• Check Module Functionality: **Module Status: Verify that all modules in the network are functioning properly. If a specific module is malfunctioning, it may disrupt communication.
• **Power and Ground: Ensure that each module has the proper power supply and ground connections.
• Test Communication Lines: **CAN Bus Testing: If the vehicle uses a CAN (Controller Area Network) bus, use a multimeter or oscilloscope to check the communication lines for proper voltage levels and signals.
• **Shorts and Opens: Look for shorts or open circuits in the communication lines.
• Check for Software Updates: **Manufacturer Updates: Check if there are any software updates available for the vehicle’s modules. Sometimes, manufacturers release updates to fix communication issues.
• Reset the System: **Clear Codes: Use the OBD-II scanner to clear the trouble codes and see if the U1351 code returns after a test drive.
• **Battery Disconnect: Disconnect the vehicle’s battery for a few minutes to reset the modules, then reconnect and check for codes again.
• Inspect for Interference: **Aftermarket Accessories: If any aftermarket accessories (like alarms, radios, etc.) have been installed, ensure they are not interfering with the vehicle’s communication network.
• Consult Technical Service Bulletins (TSBs): **Manufacturer TSBs: Look for any TSBs related to the U1351 code for your specific vehicle make and model. These bulletins may provide specific guidance or known fixes.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized diagnostic tools and experience with your vehicle’s specific communication network.
• Replace Faulty Modules: If a specific module is identified as faulty and is causing the communication issue, it may need to be replaced. By following these troubleshooting steps, you can systematically identify and resolve the underlying issue causing the U1351 code.