U1364 – Module Communication Failure

The ODBII code U1364 indicates a “Module Communication Failure,” meaning there is a problem with communication between the vehicle’s control modules, which may affect their ability to exchange data properly.

The severity of ODBII code U1364 is moderate.

Common Causes For: U1361 U1361: “Module Communication Failure”

• Faulty wiring or connectors
• Failed or malfunctioning module
• Poor ground connections
• Corroded terminals
• Intermittent communication issues
• Software or firmware issues
• Low battery voltage
• Electrical interference
• Damaged or shorted circuits
• Incompatible or missing modules

Common misdiagnosis for U1364 U1364: “Module Communication Failure”

• Faulty wiring or connectors
• Defective control module
• Software issues or updates needed
• Power supply problems
• Grounding issues
• Intermittent communication issues
• Other unrelated module failures

Common Troubleshooting Steps

The OBD-II code U1364 indicates a “Module Communication Failure,” which typically means that there is a problem with communication between the vehicle’s control modules. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead to the root cause of the communication failure.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected module(s). Look for signs of damage, corrosion, or loose connections.
• Pay special attention to ground connections, as poor grounding can lead to communication issues.
• Check Power Supply: Ensure that the affected module is receiving the proper voltage and ground. Use a multimeter to check the power and ground circuits.
• Test the Module: If possible, test the affected module to see if it is functioning correctly. This may involve bench testing or swapping with a known good module.
• Check for Intermittent Issues: Sometimes, communication failures can be intermittent. Wiggle the wiring harnesses and connectors while monitoring for changes in the code or module response.
• Inspect the CAN Bus: If the vehicle uses a Controller Area Network (CAN) bus for communication, check the integrity of the bus. Look for short circuits, open circuits, or noise on the bus lines.
• Update Software/Firmware: Check if there are any software or firmware updates available for the vehicle’s modules. Sometimes, communication issues can be resolved with an update.
• Clear Codes and Test Drive: After performing any repairs or inspections, clear the trouble codes and take the vehicle for a test drive to see if the code returns.
• Consult Service Manual: Refer to the vehicle’s service manual for specific diagnostic procedures related to the U1364 code and the affected module(s).
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership with advanced diagnostic tools. By following these steps, you can systematically identify and resolve the underlying issues causing the U1364 code.