U1398 – Control Module Communication Failure

The ODBII code U1398 indicates a “Control Module Communication Failure,” meaning there is a problem with communication between the vehicle’s control modules, which can affect various systems and functions.

The severity of ODBII code U1398 is moderate to severe.

Common Causes For: U1397 Communication Bus Off.

• Faulty control module
• Poor electrical connections
• Damaged wiring harness
• Corroded connectors
• Software issues or bugs
• Low battery voltage
• Intermittent communication issues
• Faulty CAN bus system
• Grounding issues
• Incompatible or malfunctioning aftermarket parts

Common misdiagnosis for U1398 U1398: “Control Module Communication Failure”

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Faulty sensors
• Battery or power supply problems
• Intermittent connection issues
• Communication network faults (e.g., CAN bus issues)

Common Troubleshooting Steps

The OBD-II code U1398 indicates a “Control Module Communication Failure.” This code typically suggests that there is a problem with communication between the vehicle’s control modules. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead to the root cause of the communication failure.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the control modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the wiring harnesses that connect the affected modules.
• Check Power and Ground:
• Ensure that the control modules have proper power and ground connections. Use a multimeter to check voltage and ground continuity.
• If there are issues with power or ground, repair the wiring or connections as needed.
• Test Control Modules:
• If possible, test the affected control modules individually. This may involve swapping them with known good modules or using specialized diagnostic tools.
• Ensure that the modules are functioning correctly and are not faulty.
• Inspect the CAN Bus:
• The communication between control modules often occurs over the Controller Area Network (CAN) bus. Check for any issues with the CAN bus wiring, such as shorts, opens, or interference.
• Use an oscilloscope or CAN bus diagnostic tool to monitor the bus signals for proper communication.
• Check for Software Updates:
• Sometimes, communication issues can be resolved with a software update. Check with the vehicle manufacturer for any available updates for the control modules.
• Clear Codes and Test Drive:
• After performing any repairs or inspections, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Service Manual:
• Refer to the vehicle’s service manual for specific diagnostic procedures related to the U1398 code. This may provide additional insights or steps tailored to your vehicle’s make and model.
• Seek Professional Help:
• If the issue persists after performing the above steps, consider seeking assistance from a qualified technician or automotive professional who has experience with your vehicle’s make and model. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U1398 code.