U1606 – ECM Communication Failure

The ODBII code U1606: ECM Communication Failure indicates a loss of communication between the Engine Control Module (ECM) and other control modules in the vehicle.

The severity of ODBII code U1606: ECM Communication Failure is typically considered moderate to severe.

Common Causes For: U1605 Communication Bus Fault.

• Faulty Engine Control Module (ECM)
• Poor electrical connections or wiring issues
• Corroded or damaged connectors
• Faulty communication lines (CAN bus)
• Malfunctioning sensors or modules
• Software issues or programming errors
• Battery or charging system problems
• Grounding issues

Common misdiagnosis for U1606 U1606: ECM Communication Failure

• Faulty ECM (Engine Control Module)
• Wiring issues or damaged connectors
• Faulty TCM (Transmission Control Module)
• Bad ground connections
• Faulty sensors (e.g., crankshaft or camshaft position sensors)
• Communication issues with other modules
• Battery or charging system problems
• Corroded or loose terminals
• Software issues or outdated firmware
• Faulty diagnostic tools or incorrect code reading

Common Troubleshooting Steps

The OBD-II code U1606 indicates an “ECM Communication Failure,” which typically means that the Engine Control Module (ECM) is not communicating properly with other modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or indicate related issues.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the ECM for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or damaged.
• Check Power and Ground: **Power Supply: Verify that the ECM is receiving the correct voltage. Use a multimeter to check the power supply to the ECM.
• **Ground Connections: Ensure that the ground connections for the ECM are secure and free of corrosion.
• Test the ECM: If possible, test the ECM with a known good unit to determine if the ECM itself is faulty.
• Some vehicles may have specific testing procedures for the ECM that can be found in the service manual.
• Check for Communication with Other Modules: Use a scan tool to check if other modules (like the Transmission Control Module, ABS, etc.) are communicating properly. If other modules are also not communicating, it may indicate a network issue.
• Inspect the CAN Bus: The communication between modules often occurs over a Controller Area Network (CAN) bus. Check for issues with the CAN bus wiring, such as shorts or opens.
• Use an oscilloscope to check the CAN bus signals if you have the equipment and knowledge to do so.
• Look for Software Issues: Sometimes, a software update may be required for the ECM or other modules. Check with the manufacturer for any available updates.
• Reset the Codes: After performing checks and repairs, clear the codes using the OBD-II scanner and see if the code returns after a test drive.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the U1606 code for your specific vehicle make and model. Manufacturers may have known fixes or recommendations.
• Seek Professional Help: If the issue persists after performing these steps, it may be best to consult a professional mechanic or dealership for further diagnosis.Conclusion Troubleshooting a U1606 code can involve a combination of electrical diagnostics, module testing, and sometimes software updates. Always refer to the specific service manual for your vehicle for detailed procedures and specifications.