U1630 – CAN Bus Communication Failure

The ODBII code U1630 indicates a “CAN Bus Communication Failure,” meaning there is a problem with the communication between the vehicle’s control modules over the Controller Area Network (CAN) bus.

The severity of ODBII code U1630: “CAN Bus Communication Failure” is generally considered moderate to severe.

Common Causes For: U1629 Invalid Data Received from Vehicle Control Module.

• Faulty CAN bus wiring or connectors
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Malfunctioning control modules
• Poor ground connections
• Interference from other electronic devices
• Corroded or damaged connectors
• Software issues or bugs in the control modules
• Low battery voltage or power supply issues
• Faulty termination resistors

Common misdiagnosis for U1630 U1630: “CAN Bus Communication Failure”

• Faulty CAN Bus wiring
• Defective ECU (Engine Control Unit)
• Malfunctioning sensors
• Bad ground connections
• Faulty connectors or terminals
• Issues with other communication protocols
• Power supply problems to the ECU
• Software glitches or outdated firmware
• Interference from aftermarket accessories
• Faulty or incompatible diagnostic tools

Common Troubleshooting Steps

The OBD-II code U1630 indicates a “CAN Bus Communication Failure.” This code typically points to issues with the Controller Area Network (CAN) bus, which is responsible for communication between various electronic control units (ECUs) in a vehicle. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Other codes can provide context and help identify the root cause of the problem.
• Inspect the Wiring and Connectors: Visually inspect the wiring harnesses and connectors associated with the CAN bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the connectors at the ECUs, as well as any junction points in the wiring.
• Test the CAN Bus Voltage: Use a multimeter to measure the voltage on the CAN High (CAN H) and CAN Low (CAN L) wires. The typical voltage levels should be around 2.5V when the bus is idle.
• If the voltage levels are significantly off, it may indicate a short circuit or an open circuit in the wiring.
• Check for Short Circuits: Inspect the CAN bus wiring for any short circuits to ground or to each other. This can cause communication failures.
• Disconnect the battery and use a multimeter to check for continuity between the CAN wires and ground.
• Test the ECUs: If the wiring appears to be in good condition, the issue may lie with one of the ECUs on the CAN bus. Disconnect each ECU one at a time and check if the code clears.
• If disconnecting a specific ECU resolves the issue, that ECU may be faulty.
• Check for Interference: Ensure that there are no aftermarket devices or modifications that could be interfering with the CAN bus communication.
• Devices such as alarms, remote starters, or other electronic accessories can sometimes cause issues.
• Inspect the CAN Bus Termination Resistors: The CAN bus requires termination resistors at both ends of the bus. Check to ensure that these resistors are present and functioning correctly (typically 120 ohms).
• If the resistors are missing or damaged, it can lead to communication failures.
• Perform a Network Test: Use a professional scan tool capable of performing a CAN bus network test. This can help identify which ECU is not communicating properly.
• Check for Software Updates: Sometimes, a software update for the vehicle’s ECUs can resolve communication issues. Check with the manufacturer for any available updates.
• Consult a Professional: If the issue persists after performing these steps, it may be best to consult a professional mechanic or technician who specializes in automotive electronics.Conclusion Troubleshooting a U1630 code can be complex due to the nature of the CAN bus system. Following these steps systematically can help identify and resolve the underlying issue. Always ensure safety precautions are taken when working with vehicle electronics.