U1631 – CAN Bus Communication Fault in Body Control Module

The ODBII code U1631 indicates a communication fault on the CAN bus related to the Body Control Module, suggesting that the module is not receiving or sending data properly within the vehicle’s network.

The severity of ODBII code U1631 is moderate to high.

Common Causes For: U1630 U1630: “CAN Bus Communication Failure”

• Faulty Body Control Module (BCM)
• Damaged or corroded wiring/connectors in the CAN bus
• Poor ground connections
• Faulty CAN bus transceiver
• Intermittent electrical connections
• Software issues or programming errors in the BCM
• Other module communication failures on the CAN bus
• Short circuits or open circuits in the CAN bus wiring

Common misdiagnosis for U1631 U1631: CAN Bus Communication Fault in Body Control Module

• Faulty Body Control Module (BCM)
• Wiring issues or shorts in the CAN bus
• Faulty CAN bus connectors
• Defective sensors or actuators connected to the BCM
• Power supply issues to the BCM
• Software or firmware issues in the BCM
• Other module communication faults (e.g., engine control module)
• Grounding issues related to the BCM or CAN bus
• Intermittent faults due to temperature or vibration
• Incorrectly diagnosed electrical issues elsewhere in the vehicle.

Common Troubleshooting Steps

When dealing with OBD-II code U1631, which indicates a CAN Bus Communication Fault in the Body Control Module (BCM), there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context and help identify related issues.
• Inspect the Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the BCM and CAN bus for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or pushed back.
• Test the CAN Bus: **CAN Bus Voltage: Use a multimeter to check the voltage levels on the CAN High and CAN Low wires. The typical voltage should be around 2.5V when the bus is idle.
• **Signal Integrity: Use an oscilloscope to check for proper signal waveforms on the CAN bus lines. Look for clean square wave signals.
• Check for Short Circuits: Inspect the CAN bus wiring for any shorts to ground or power. A short can disrupt communication between modules.
• Inspect the Body Control Module: **Physical Condition: Check the BCM for any signs of physical damage or water intrusion.
• **Reprogramming: If the BCM is suspected to be faulty, consider reprogramming or updating the software if applicable.
• Test Other Modules: If other modules are connected to the CAN bus, check their functionality. A malfunctioning module can affect the entire bus communication.
• Check for Intermittent Issues: Sometimes, the issue may be intermittent. Pay attention to when the code appears (e.g., during specific conditions like temperature changes or after certain actions).
• Clear Codes and Test Drive: After performing checks and repairs, clear the codes and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any manufacturer-specific TSBs related to the U1631 code or CAN bus communication issues. There may be known fixes or recalls.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership with experience in diagnosing CAN bus issues.Conclusion Troubleshooting a U1631 code can be complex due to the nature of CAN bus communication. Following these steps systematically can help isolate the problem and lead to a resolution. Always ensure safety and proper procedures when working on vehicle electronics.