U1719 – Transmission Control Module Communication Error

By Fixitfor.us |
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

The ODBII code U1719 indicates a communication error between the Transmission Control Module (TCM) and other control modules in the vehicle, suggesting a potential issue with data transmission or connectivity.

The severity of ODBII code U1719 is moderate to severe.

Common Causes For: U1718 U1718: Transmission Control Module Communication Error

  • Faulty Transmission Control Module (TCM)
  • Damaged wiring or connectors
  • Poor electrical connections
  • Failed or malfunctioning engine control module (ECM)
  • Software issues or programming errors
  • Low transmission fluid levels
  • Faulty sensors related to transmission operation
  • Corroded or shorted circuits

Common misdiagnosis for U1719 U1719: Transmission Control Module Communication Error

  • Faulty Transmission Control Module (TCM)
  • Wiring or connector issues
  • Faulty Engine Control Module (ECM)
  • Transmission fluid issues
  • Sensor malfunctions (e.g., speed sensors)
  • Battery or charging system problems
  • Software or firmware issues in the TCM or ECM
  • Grounding issues in the electrical system

Common Troubleshooting Steps

The OBD-II code U1719 indicates a communication error between the Transmission Control Module (TCM) and other control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

  • Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Addressing other related codes may help resolve the U1719 code.
  • Inspect Wiring and Connectors:
  • Visually inspect the wiring and connectors related to the TCM. Look for signs of damage, corrosion, or loose connections.
  • Pay special attention to the wiring harness that connects the TCM to the vehicle’s main harness.
  • Check Power and Ground:
  • Ensure that the TCM is receiving proper power and ground. Use a multimeter to check the voltage at the TCM connector.
  • Verify that the ground connections are clean and secure.
  • Test the TCM:
  • If possible, test the TCM for proper operation. This may involve using specialized diagnostic equipment or swapping in a known good TCM if available.
  • Inspect Other Modules:
  • Check the communication between the TCM and other modules (like the Engine Control Module (ECM) or Body Control Module (BCM)). Ensure that these modules are functioning correctly and that their connections are secure.
  • Check for Short Circuits:
  • Look for any short circuits in the wiring that could be causing communication issues. This may require a more in-depth inspection of the wiring harness.
  • Update Software/Firmware:
  • In some cases, updating the software or firmware of the TCM or other related modules may resolve communication issues.
  • Clear Codes and Test Drive:
  • After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
  • Consult Service Manual:
  • Refer to the vehicle’s service manual for specific diagnostic procedures and wiring diagrams related to the TCM and communication networks.
  • Seek Professional Help:
  • If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with transmission control systems and can perform more advanced diagnostics. By following these steps, you should be able to identify and resolve the underlying issue causing the U1719 code.

Leave a Comment

You must be logged in to post a comment.