U1733 – Control Module Communication Failure

The ODBII code U1733 indicates a “Control Module Communication Failure,” meaning there is a problem with communication between the vehicle’s control modules, which can affect various systems and functions.

The severity of ODBII code U1733 is moderate.

Common Causes For: U1732 U1732: “Module Communication Failure”

• Faulty wiring or connectors
• Failed control module
• Poor ground connections
• Corroded or damaged connectors
• Communication network issues (e.g., CAN bus problems)
• Software or firmware issues in the control module
• Low battery voltage or power supply issues
• Interference from aftermarket devices or modifications

Common misdiagnosis for U1733 U1733: “Control Module Communication Failure”

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Faulty sensors
• Battery or power supply issues
• Intermittent connection problems
• Communication network faults (CAN bus issues)

Common Troubleshooting Steps

The OBD-II code U1733 indicates a “Control Module Communication Failure.” This code typically points to a problem with communication between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Addressing related codes can help pinpoint the issue.
• Inspect Wiring and Connectors: Visually inspect the wiring and connectors associated with the control modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the wiring harnesses that connect the affected modules.
• Check Power and Ground: Ensure that the control modules have proper power and ground connections. Use a multimeter to check voltage and ground continuity.
• Verify that the fuses related to the control modules are intact.
• Test Control Modules: If possible, test the affected control module(s) for functionality. This may involve using specialized diagnostic tools or software.
• If a module is suspected to be faulty, consider replacing it with a known good unit for testing purposes.
• Inspect the CAN Bus: The Controller Area Network (CAN) bus is responsible for communication between modules. Check for any issues with the CAN bus wiring.
• Use an oscilloscope or CAN bus diagnostic tool to monitor the bus for proper communication signals.
• Check for Software Updates: Sometimes, communication issues can be resolved with a software update. Check with the manufacturer for any available updates for the control modules.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner.
• Take the vehicle for a test drive to see if the code reappears. Monitor the vehicle’s performance and any warning lights.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common issues related to U1733.
• Seek Professional Help: If the issue persists after performing the above steps, consider seeking assistance from a qualified mechanic or dealership. They may have access to advanced diagnostic tools and resources.Conclusion Troubleshooting a U1733 code can be complex due to the nature of control module communication. Following these steps systematically can help identify and resolve the underlying issue. Always refer to the vehicle’s service manual for specific procedures and specifications.