U1741 – Module Communication Failure

The ODBII code U1741: Module Communication Failure indicates that there is a communication issue between the vehicle’s control modules, preventing them from exchanging data properly.

The severity of ODBII code **U1741: Module Communication Failure** is generally considered moderate to severe.

Common Causes For: U1658: Communication Network Malfunction

• Faulty wiring or connectors
• Failed control module
• Corrupted software or firmware
• Poor ground connections
• Interference from aftermarket devices
• Low battery voltage
• Damaged or corroded pins in connectors
• Communication network issues (e.g., CAN bus problems)

Common misdiagnosis for U1741: Module Communication Failure

• Faulty wiring or connectors
• Defective control module
• Software issues or firmware corruption
• Power supply problems
• Grounding issues
• Intermittent communication faults
• Incorrectly configured or programmed modules
• Other communication protocol failures

Common Troubleshooting Steps

The OBD-II code **U1741: Module Communication Failure** indicates that there is a communication issue between the vehicle’s control modules. This can be caused by various factors, including wiring issues, faulty modules, or problems with the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context and help identify the root cause of the communication failure.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the wiring harnesses that connect the modules, as these can be prone to wear and tear.
• Check Power and Ground:
• Ensure that the affected module(s) are receiving proper power and ground. Use a multimeter to check voltage and ground continuity.
• If the module is not receiving power, trace the circuit back to the fuse box and check for blown fuses or damaged wiring.
• Test the Communication Network:
• Use a scan tool to monitor the communication between modules. Check if other modules are communicating properly.
• If you have access to a professional-grade scan tool, you can perform a network test to identify any communication faults.
• Inspect the Affected Module:
• If the wiring and connections are good, the issue may lie within the affected module itself. If possible, test the module in another vehicle to see if it functions correctly.
• If the module is faulty, it may need to be repaired or replaced.
• Check for Software Updates:
• Sometimes, communication issues can be resolved with a software update. Check with the vehicle manufacturer for any available updates for the affected module(s).
• Clear Codes and Test Drive:
• After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs):
• Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known communication issues.
• Seek Professional Help:
• If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who specializes in automotive electronics and diagnostics. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U1741 code.