U1752 – Data Bus Communication Failure

The ODBII code U1752 indicates a data bus communication failure, meaning there is a problem with the communication between various control modules in the vehicle’s network.

The severity of ODBII code U1752 is moderate to severe.

Common Causes For: U1751 U1751: “Module Communication Failure”

• Faulty wiring or connectors in the data bus system
• Malfunctioning control modules
• Poor ground connections
• Corroded or damaged terminals
• Interference from aftermarket devices
• Software issues or bugs in the control modules
• Low battery voltage or power supply issues
• Faulty or damaged data bus communication lines

Common misdiagnosis for U1752 U1752: Data Bus Communication Failure

• Faulty ABS module
• Defective engine control module (ECM)
• Malfunctioning transmission control module (TCM)
• Bad wiring or connectors
• Faulty body control module (BCM)
• Issues with the powertrain control module (PCM)
• Incorrectly diagnosed sensor failures
• Battery or charging system problems

Common Troubleshooting Steps

The OBD-II code U1752 indicates a “Data Bus Communication Failure.” This code typically points to issues with the communication between various modules in the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Look for damaged, corroded, or loose connectors and wiring related to the data bus. Pay special attention to the connectors of the modules involved in the communication.
• **Repair or Replace: If any damaged wiring or connectors are found, repair or replace them as necessary.
• Check the Modules: **Module Functionality: Ensure that all modules on the data bus are functioning correctly. A malfunctioning module can disrupt communication.
• **Power and Ground: Verify that each module has the proper power supply and ground connections.
• Test the Data Bus: **Multimeter or Oscilloscope: Use a multimeter or oscilloscope to check the voltage levels and signal integrity on the data bus. Look for any irregularities in the communication signals.
• **Bus Termination: Ensure that the data bus is properly terminated, as improper termination can lead to communication issues.
• Check for Interference: **Electrical Interference: Look for sources of electrical interference that could affect data communication, such as aftermarket accessories or modifications.
• Reset the Codes: After performing inspections and repairs, clear the codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any manufacturer-specific TSBs related to U1752 or data bus communication issues. There may be known fixes or recalls that apply to your vehicle.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized diagnostic tools and experience with your specific vehicle make and model.
• Check for Software Updates: Sometimes, a software update for the vehicle’s modules can resolve communication issues. Check with the manufacturer or dealership for any available updates. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U1752 code.