U1758 – Module Communication Failure

The ODBII code U1758 indicates a “Module Communication Failure,” meaning there is a problem with communication between vehicle control modules, often due to a wiring issue, a faulty module, or a network problem.

The severity of ODBII code U1758 is generally considered moderate to severe.

Common Causes For: U1757 U1757: “Module Communication Failure”

• Faulty wiring or connectors
• Failed or malfunctioning module
• Poor ground connections
• Corroded or damaged pins
• Communication network issues (e.g., CAN bus problems)
• Software or firmware issues
• Intermittent electrical connections
• Low battery voltage or power supply issues

Common misdiagnosis for U1758 U1758: “Module Communication Failure”

• Faulty wiring or connectors
• Defective control module
• Software issues or updates needed
• Power supply problems
• Grounding issues
• Intermittent communication issues
• Other communication protocol failures

Common Troubleshooting Steps

The OBD-II code U1758 indicates a “Module Communication Failure,” which typically means that there is a problem with communication between various modules in the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead to the root cause of the communication failure.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harnesses and connectors associated with the affected module(s) for any signs of damage, corrosion, or loose connections.
• **Repair or Replace: Repair any damaged wires or connectors and ensure that all connections are secure.
• Check Power and Ground: **Power Supply: Verify that the affected module is receiving the correct voltage. Use a multimeter to check the power supply to the module.
• **Ground Connections: Ensure that the ground connections for the module are clean and secure.
• Test the Module: If possible, test the affected module to ensure it is functioning correctly. This may involve using specialized diagnostic tools or swapping the module with a known good one.
• Check for Communication Issues: **CAN Bus Communication: If the vehicle uses a Controller Area Network (CAN) bus, check for proper communication between modules. You may need a scan tool that can monitor live data to see if other modules are communicating correctly.
• **Termination Resistors: Ensure that the CAN bus has the correct termination resistors in place, as improper termination can lead to communication failures.
• Inspect for Interference: Look for any aftermarket devices or modifications that may interfere with the vehicle’s communication network. This includes alarm systems, stereo systems, or other electronic devices.
• Update Software/Firmware: Check if there are any software or firmware updates available for the vehicle’s modules. Sometimes, communication issues can be resolved with an update.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Service Manual: Refer to the vehicle’s service manual for specific diagnostic procedures related to the U1758 code and the modules involved.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with the specific make and model of your vehicle. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U1758 code.