U1766 – Module Communication Failure

The ODBII code U1766: Module Communication Failure indicates that there is a communication issue between the vehicle’s control modules, preventing them from exchanging data properly.

The severity of ODBII code **U1766: Module Communication Failure** is generally considered moderate to severe.

Common Causes For: U1764: Module Communication Fault

• Faulty wiring or connectors
• Failed or malfunctioning control module
• Corrupted software or firmware in the module
• Poor ground connections
• Interference from aftermarket devices
• Low battery voltage or power supply issues
• Communication network issues (e.g., CAN bus problems)
• Damaged or corroded pins in connectors
• Incompatible or missing modules in the network

Common misdiagnosis for U1766: Module Communication Failure

• Faulty wiring or connectors
• Defective control module
• Software issues or updates needed
• Power supply problems
• Grounding issues
• Intermittent communication issues
• Other communication protocol failures
• Sensor malfunctions

Common Troubleshooting Steps

The OBD-II code **U1766: Module Communication Failure** indicates that there is a communication issue between the vehicle’s control modules. This can be caused by various factors, including wiring issues, faulty modules, or problems with the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context about the issue and help identify which module is having communication problems.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication failures.
• Check the CAN Bus:
• The Controller Area Network (CAN) bus is responsible for communication between modules. Use a multimeter or oscilloscope to check for proper voltage levels and signal integrity on the CAN bus wires.
• Look for short circuits, open circuits, or any other abnormalities in the wiring.
• Test the Affected Module:
• If a specific module is identified as the source of the problem, test it for functionality. This may involve checking for power and ground at the module, as well as verifying that it is receiving and sending data correctly.
• If possible, swap the module with a known good one to see if the problem persists.
• Check for Software Updates:
• Sometimes, communication issues can be resolved by updating the software or firmware of the affected modules. Check with the manufacturer for any available updates.
• Inspect for Intermittent Issues:
• If the code is intermittent, try to replicate the conditions under which the code appears. This may involve driving the vehicle under specific conditions or checking for temperature-related issues.
• Clear Codes and Test Drive:
• After performing any repairs or adjustments, clear the trouble codes and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs):
• Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common communication issues and their resolutions.
• Professional Diagnosis:
• If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized diagnostic tools and experience with the specific vehicle. By following these steps, you can systematically diagnose and address the U1766 code and its underlying causes.