U1853 – Module Communication Failure

The ODBII code U1853 indicates a “Module Communication Failure,” meaning there is a problem with communication between the vehicle’s control modules, often due to a wiring issue, a faulty module, or a network problem.

The severity of ODBII code U1853 is moderate.

Common Causes For: U1852 Lost Communication with Body Control Module (BCM) – Bus Off.

• Faulty wiring or connectors
• Failed control module
• Poor ground connections
• Corroded terminals
• Intermittent communication issues
• Software or firmware issues
• Low battery voltage
• Electrical interference
• Damaged or shorted communication lines
• Incompatible or missing modules

Common misdiagnosis for U1853 U1853: “Module Communication Failure”

• Faulty wiring or connectors
• Defective control modules
• Battery or power supply issues
• Software or firmware glitches
• Communication protocol errors
• Grounding issues
• Intermittent faults in the network
• Incorrectly configured aftermarket accessories

Common Troubleshooting Steps

The OBD-II code U1853 indicates a “Module Communication Failure,” which typically means that there is a problem with communication between various modules in the vehicle’s network. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, U-codes can be related to other issues that may provide more context.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the wiring harnesses that connect the modules, as these can be prone to wear and tear.
• Check Power and Ground:
• Ensure that the affected modules are receiving proper power and ground. Use a multimeter to check voltage and ground continuity at the module connectors.
• If there is no power or ground, trace the wiring back to the source to identify any breaks or shorts.
• Test the Modules:
• If possible, test the affected modules individually to ensure they are functioning correctly. This may involve using specialized diagnostic tools or software.
• If a module is found to be faulty, it may need to be repaired or replaced.
• Check for Communication:
• Use a scan tool to check for communication between the modules. Some scan tools can perform a network test to see if all modules are communicating properly.
• If certain modules are not responding, it may indicate a problem with those specific modules or their connections.
• Inspect the CAN Bus:
• The Controller Area Network (CAN) bus is responsible for communication between modules. Inspect the CAN bus wiring for damage or shorts.
• Use an oscilloscope to check the signal integrity on the CAN bus if you have access to one.
• Reset the Modules:
• Sometimes, simply resetting the modules by disconnecting the battery for a few minutes can clear temporary communication issues.
• After reconnecting the battery, check if the code reappears.
• Update Software/Firmware:
• Check if there are any software or firmware updates available for the vehicle’s modules. Sometimes, communication issues can be resolved with an update.
• Consult Technical Service Bulletins (TSBs):
• Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known communication issues.
• Professional Diagnosis:
• If the issue persists after performing the above steps, it may be necessary to seek professional help from a qualified technician or dealership, as they may have access to advanced diagnostic tools and resources. By following these steps, you should be able to identify and resolve the underlying cause of the U1853 code.