U1866 – Inter-Module Communication Failure

The ODBII code U1866 indicates a failure in communication between modules in a vehicle’s network, suggesting that one or more electronic control units (ECUs) are unable to exchange data properly.

The severity of ODBII code U1866 is moderate.

Common Causes For: U1865 U1865: “Module Communication Failure”

• Faulty wiring or connectors
• Failed control module
• Corrupted software or firmware
• Poor ground connections
• Intermittent electrical issues
• Low battery voltage
• Communication network issues (e.g., CAN bus problems)
• Damaged or corroded terminals

Common misdiagnosis for U1866 U1866: “Inter-Module Communication Failure”

• Faulty wiring or connectors
• Defective control modules
• Low battery voltage
• Corroded terminals
• Software issues or updates needed
• Intermittent electrical connections
• Grounding issues
• Faulty sensors

Common Troubleshooting Steps

The OBD-II code U1866 indicates an “Inter-Module Communication Failure,” which typically means that there is a problem with the communication between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead you to the root cause of the communication failure.
• Inspect Wiring and Connectors:
• Visually inspect the wiring harnesses and connectors associated with the modules involved in communication. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to ground connections, as poor grounding can lead to communication issues.
• Check Power Supply: Ensure that the control modules are receiving the proper voltage. Use a multimeter to check the power supply to the affected modules.
• Test the Modules:
• If possible, test the affected control modules individually to ensure they are functioning correctly. This may involve using specialized diagnostic tools or software.
• If a module is found to be faulty, it may need to be repaired or replaced.
• Inspect the CAN Bus:
• The Controller Area Network (CAN) bus is responsible for communication between modules. Check for any shorts, opens, or faults in the CAN bus wiring.
• Use an oscilloscope or a CAN bus diagnostic tool to monitor the bus for proper signal levels and communication.
• Check for Software Updates: Sometimes, communication issues can be resolved with a software update. Check with the vehicle manufacturer for any available updates for the control modules.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known issues that could be relevant.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with the specific vehicle and its systems. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U1866 code.