U2067 – Control Module Communication Bus Off.

The ODBII code U2067 indicates a communication issue where a control module is not able to communicate over the vehicle’s communication bus, often due to a fault in the module or wiring.

The severity of ODBII code U2067 is moderate to severe.

Common Causes For: U2066 Control Module Communication Bus Off.

• Faulty control module
• Damaged wiring or connectors
• Poor ground connections
• Communication bus failure
• Short circuit in the communication lines
• Corroded connectors
• Software issues or bugs in the control module
• Battery voltage issues
• Interference from aftermarket devices
• Faulty or malfunctioning sensors

Common misdiagnosis for U2067 Control Module Communication Bus Off.

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Faulty sensors
• Battery or power supply problems
• Communication network issues
• Intermittent connection problems

Common Troubleshooting Steps

The OBD-II code U2067 indicates a communication issue on the control module communication bus, specifically that a module is “off” or not responding. This can be caused by various issues, including wiring problems, module failures, or issues with the communication bus itself. Here are some common troubleshooting steps to diagnose and resolve the U2067 code:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context about the issue.
• Inspect Wiring and Connectors: Visually inspect the wiring and connectors related to the control modules on the communication bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication issues.
• Check the Control Modules: Identify the control module that is reporting the U2067 code. This may require consulting the vehicle’s service manual.
• If possible, test the control module for proper operation. This may involve checking for power and ground at the module, as well as verifying that it is functioning correctly.
• Test the Communication Bus: Use a multimeter or an oscilloscope to check the communication signals on the bus. Look for proper voltage levels and signal integrity.
• If you have access to a scan tool that can monitor live data, check for communication between modules.
• Check for Short Circuits or Open Circuits: Use a multimeter to check for short circuits or open circuits in the communication lines. This may involve checking the resistance of the wires and ensuring they are not shorted to ground or each other.
• Inspect for Interference: Check for any aftermarket devices or modifications that may be interfering with the communication bus. This includes alarms, stereo systems, or other electronic devices.
• Reset the Codes: After performing checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the U2067 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues.
• Replace Faulty Components: If a specific control module is determined to be faulty, replace it. Ensure that any new module is properly programmed and configured for the vehicle.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with automotive electronics and communication systems. By following these troubleshooting steps, you should be able to identify and resolve the underlying issue causing the U2067 code.