U2106 – Lost Communication with Vehicle Dynamics Control Module.

The ODBII code U2106 indicates a loss of communication between the vehicle’s control module and the Vehicle Dynamics Control Module, which may affect systems like traction control and stability control.

The severity of ODBII code U2106 is generally considered moderate to high.

Common Causes For: U2105 Lost Communication with Vehicle Control Module.

• Faulty Vehicle Dynamics Control Module (VDCM)
• Damaged or corroded wiring or connectors
• Poor ground connection
• Faulty communication lines (CAN bus issues)
• Software or firmware issues in the VDCM
• Malfunctioning other related control modules
• Battery voltage issues or low power supply
• Intermittent electrical connections

Common misdiagnosis for U2106 Lost Communication with Vehicle Dynamics Control Module.

• Faulty ABS module
• Wiring issues or shorts
• Defective wheel speed sensors
• Malfunctioning engine control module (ECM)
• Issues with the powertrain control module (PCM)
• Battery or charging system problems
• Faulty connectors or terminals
• Software or firmware issues in the control modules

Common Troubleshooting Steps

The OBD-II code U2106 indicates a “Lost Communication with Vehicle Dynamics Control Module.” This code typically points to a communication issue between the Engine Control Module (ECM) and the Vehicle Dynamics Control Module (VDCM). Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context or indicate related issues.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the Vehicle Dynamics Control Module for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or damaged.
• Check Power and Ground: Verify that the Vehicle Dynamics Control Module is receiving the correct power supply and ground. Use a multimeter to check voltage and continuity.
• Test the Vehicle Dynamics Control Module: If possible, perform a bench test on the VDCM to ensure it is functioning correctly. This may require specialized equipment or tools.
• Inspect the CAN Bus: The communication between modules typically occurs over the Controller Area Network (CAN) bus. Check for:
• Short circuits or open circuits in the CAN bus wiring.
• Proper termination resistors at the ends of the CAN bus.
• Signal integrity using an oscilloscope if available.
• Check for Software Updates: Sometimes, communication issues can be resolved with a software update. Check with the manufacturer for any available updates for the ECM or VDCM.
• Clear Codes and Test Drive: After performing any repairs or checks, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U2106 code or the specific vehicle model. Manufacturers may have issued guidance on common issues and fixes.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have access to advanced diagnostic tools and resources.
• Replace the Module (if necessary): If all other troubleshooting steps fail and the VDCM is confirmed to be faulty, replacement of the module may be necessary.Conclusion Always follow safety precautions when working on a vehicle’s electrical system. If you’re not comfortable performing these steps, it’s best to consult a professional mechanic.