U2193 – Body Control Module Communication Failure

The ODBII code U2193 indicates a communication failure between the Body Control Module (BCM) and other modules in the vehicle, suggesting a problem with data exchange or connectivity.

The severity of ODBII code U2193 is moderate to severe.

Common Causes For: U2192 U2192: “Module Communication Failure”

• Faulty Body Control Module (BCM)
• Damaged wiring or connectors
• Poor ground connections
• Corroded terminals
• Software issues or bugs in the BCM
• Malfunctioning communication network (CAN bus)
• Other module failures affecting communication
• Battery voltage issues or low power supply

Common misdiagnosis for U2193 U2193: Body Control Module Communication Failure

• Faulty Body Control Module (BCM)
• Wiring issues or short circuits
• Faulty connectors or terminals
• Malfunctioning sensors
• Power supply issues
• Faulty Engine Control Module (ECM)
• Communication issues with other modules
• Software glitches or updates needed
• Grounding problems
• Battery or charging system issues

Common Troubleshooting Steps

When dealing with OBD-II code U2193, which indicates a Body Control Module (BCM) communication failure, there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring and connectors related to the BCM for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent or corroded.
• Check Power and Ground: **Power Supply: Verify that the BCM is receiving the correct voltage. Use a multimeter to check the power supply to the BCM.
• **Ground Connections: Ensure that the ground connections for the BCM are secure and free of corrosion.
• Inspect the BCM: **Physical Condition: Check the BCM for any signs of physical damage or water intrusion.
• **Reprogramming: If the BCM has been replaced, ensure that it has been properly programmed to the vehicle.
• Check Communication Lines: **CAN Bus: If your vehicle uses a Controller Area Network (CAN) bus, check the communication lines for continuity and proper resistance.
• **Network Issues: Look for any other modules on the network that may be causing communication issues.
• Test the BCM: If possible, test the BCM with a scan tool that can communicate with it. This can help determine if the module is functioning correctly.
• If you have access to a known good BCM, you can swap it out to see if the issue resolves.
• Check for Software Updates: Sometimes, manufacturers release software updates for the BCM. Check with the dealership or manufacturer to see if there are any updates available.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Consult a Professional: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with your specific vehicle make and model.Additional Tips: – Always refer to the vehicle’s service manual for specific diagnostic procedures and specifications. – Be cautious when working with electrical components to avoid further damage. By following these steps, you should be able to identify the cause of the U2193 code and take appropriate action to resolve the communication failure with the Body Control Module.