U2202 – Module Communication Failure

The ODBII code U2202 indicates a “Module Communication Failure,” meaning there is a problem with communication between the vehicle’s control modules, which may affect their ability to exchange data properly.

The severity of ODBII code U2202 is moderate.

Common Causes For: U2201 U2201: “Control Module Communication Failure”

• Faulty wiring or connectors
• Failed control module
• Poor ground connections
• Corroded or damaged pins
• Communication network issues (e.g., CAN bus problems)
• Software or firmware issues
• Intermittent electrical connections
• Low battery voltage or power supply issues

Common misdiagnosis for U2202 U2202: “Module Communication Failure”

• Faulty wiring or connectors
• Defective control module
• Power supply issues
• Grounding problems
• Software glitches or updates needed
• Intermittent communication issues
• Other communication protocol failures
• Sensor malfunctions

Common Troubleshooting Steps

The OBD-II code U2202 indicates a “Module Communication Failure,” which typically means that there is a problem with communication between the vehicle’s control modules. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead you to the root cause of the communication failure.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication issues.
• Check Power Supply: Ensure that the affected modules are receiving the proper voltage. Use a multimeter to check the power supply to the modules in question.
• Test Communication Lines:
• Use a scan tool to check the communication lines (CAN bus, LIN bus, etc.) for continuity and proper voltage levels.
• If you have access to an oscilloscope, you can check the signal waveforms on the communication lines to ensure they are functioning correctly.
• Inspect Modules:
• If you suspect a specific module is causing the issue, consider testing or replacing it.
• If possible, swap the suspected module with a known good one to see if the problem persists.
• Check for Interference: Look for any aftermarket devices or modifications that may interfere with the vehicle’s communication network, such as alarms, remote starters, or other electronic accessories.
• Perform a Network Test: Some advanced scan tools can perform a network test to identify communication issues between modules. This can help pinpoint the specific module that is not communicating properly.
• Reset the System: After performing checks and repairs, clear the codes using the OBD-II scanner and see if the code returns. Sometimes, a simple reset can resolve temporary communication issues.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known communication issues.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with the specific vehicle and its communication systems. By following these steps, you can systematically diagnose and potentially resolve the U2202 code and the underlying communication failure.