U2222 – Module Communication Failure

The ODBII code U2222 indicates a “Module Communication Failure,” meaning there is a problem with communication between vehicle control modules, which may affect their ability to share data or function properly.

The severity of ODBII code U2222 is generally considered moderate to severe.

Common Causes For: U2221 Lost Communication with Vehicle Dynamics Control Module.

• Faulty wiring or connectors
• Failed control module
• Corrupted software or firmware
• Poor ground connections
• Interference from other electronic devices
• Low battery voltage
• Damaged or corroded pins in connectors
• Communication network issues (e.g., CAN bus problems)

Common misdiagnosis for U2222 U2222: “Module Communication Failure”

• Faulty wiring or connectors
• Defective control module
• Software issues or firmware corruption
• Power supply problems
• Grounding issues
• Intermittent communication issues
• Other communication protocol failures
• Sensor malfunctions

Common Troubleshooting Steps

The OBD-II code U2222 indicates a “Module Communication Failure,” which typically means that there is a problem with communication between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Start by scanning the vehicle for any other diagnostic trouble codes (DTCs). Sometimes, U2222 may be accompanied by other codes that can provide additional context for the issue.
• Inspect Wiring and Connectors: Examine the wiring and connectors associated with the affected modules. Look for signs of damage, corrosion, loose connections, or broken wires. Pay special attention to ground connections, as poor grounding can lead to communication issues.
• Check Power Supply: Ensure that the affected modules are receiving the proper voltage and ground. Use a multimeter to check the power supply to the modules in question.
• Verify Module Functionality: If possible, test the affected module(s) to ensure they are functioning correctly. This may involve using a scan tool to access the module and check for any internal faults.
• Inspect the CAN Bus: The Controller Area Network (CAN) bus is responsible for communication between modules. Check for any issues with the CAN bus wiring, such as shorts, opens, or interference. You can use an oscilloscope to monitor the CAN signals for proper voltage levels and signal integrity.
• Check for Software Updates: Sometimes, communication issues can be resolved with a software update. Check with the vehicle manufacturer or a dealership to see if there are any available updates for the affected modules.
• Reset the Modules: Disconnect the battery for a few minutes to reset the modules. After reconnecting, check if the code reappears.
• Perform a Network Test: If you have access to advanced diagnostic tools, perform a network test to identify any communication failures between modules.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known issues that could be relevant.
• Replace Faulty Modules: If all other steps fail and a specific module is identified as faulty, consider replacing it. Ensure that the replacement module is compatible with the vehicle. 1
• Professional Diagnosis: If you are unable to resolve the issue, consider seeking help from a professional mechanic or automotive technician who has experience with OBD-II systems and module communication issues. By following these steps, you should be able to identify and address the underlying cause of the U2222 code.