U2246 – Vehicle Communication Bus Malfunction

The ODBII code U2246 indicates a malfunction in the vehicle communication bus, which affects the communication between various control modules in the vehicle.

The severity of ODBII code U2246 is moderate.

Common Causes For: U2244 U2244: Vehicle Communication Bus Malfunction

• Faulty OBD-II connector
• Damaged wiring or connectors
• Malfunctioning control modules
• Poor ground connections
• Corroded terminals
• Software issues or bugs
• Interference from aftermarket devices
• Low battery voltage
• Faulty communication lines (CAN bus)

Common misdiagnosis for U2246 Vehicle Communication Bus Malfunction

• Faulty ECM (Engine Control Module)
• Bad wiring or connectors
• Defective CAN bus modules
• Incorrectly diagnosed sensor issues
• Power supply problems
• Faulty body control module (BCM)
• Issues with the diagnostic tool or scanner
• Software or firmware issues in the vehicle’s systems

Common Troubleshooting Steps

The OBD-II code U2246 indicates a “Vehicle Communication Bus Malfunction.” This code typically points to issues with the communication between various modules in the vehicle, often related to the Controller Area Network (CAN) bus. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Addressing other related codes may help resolve the U2246 code.
• Inspect the Wiring and Connectors: **Visual Inspection: Look for damaged, frayed, or corroded wiring and connectors related to the CAN bus.
• **Connector Integrity: Ensure that all connectors are securely attached and free of corrosion.
• Check the CAN Bus: **Resistance Test: Measure the resistance of the CAN bus. It should typically be around 60 ohms. If the resistance is too high or too low, there may be a short or an open circuit.
• **Signal Integrity: Use an oscilloscope to check the signal on the CAN bus. Look for clean square wave signals. Distorted signals can indicate a problem.
• Inspect Modules: **Module Functionality: Check if all modules on the CAN bus are functioning properly. A malfunctioning module can disrupt communication.
• **Reprogram or Reset Modules: Sometimes, reprogramming or resetting the affected modules can resolve communication issues.
• Check for Ground Issues: Ensure that all ground connections related to the CAN bus are secure and free of corrosion. Poor grounding can lead to communication problems.
• Battery and Power Supply: **Voltage Check: Ensure the vehicle’s battery is fully charged and that the voltage is within the normal range (typically 12-14 volts).
• **Check Fuses: Inspect relevant fuses for the CAN bus and modules. Replace any blown fuses.
• Scan Tool Communication: Verify that the OBD-II scanner can communicate with the vehicle. If the scanner cannot connect, it may indicate a broader communication issue.
• Look for Environmental Factors: Check for any recent modifications or repairs that may have affected the vehicle’s electrical system. Environmental factors like moisture or dirt can also cause issues.
• Consult Technical Service Bulletins (TSBs): Check for any manufacturer-specific TSBs related to the U2246 code. There may be known issues or recalls that could provide guidance.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose complex communication issues.Conclusion Troubleshooting a U2246 code can be complex due to the nature of vehicle communication systems. Following these steps systematically can help identify and resolve the underlying issue. Always refer to the vehicle’s service manual for specific procedures and specifications.