U2251 – CAN Bus Communication Failure

The ODBII code U2251 indicates a “CAN Bus Communication Failure,” meaning there is a problem with the communication between the vehicle’s control modules over the Controller Area Network (CAN) bus.

The severity of ODBII code U2251 is moderate to severe.

Common Causes For: U2250 U2250: Control Module Communication Bus Fault

• Faulty CAN bus wiring or connectors
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Faulty or malfunctioning control modules
• Poor ground connections
• Interference from other electronic devices
• Corroded or damaged terminals
• Software issues or bugs in the control modules
• Low battery voltage or power supply issues
• Faulty termination resistors

Common misdiagnosis for U2251 U2251: “CAN Bus Communication Failure”

• Faulty CAN Bus wiring
• Defective ECU (Engine Control Unit)
• Malfunctioning sensors
• Bad ground connections
• Faulty or incompatible aftermarket accessories
• Corrupted software or firmware in the ECU
• Issues with other communication protocols (e.g., LIN, K-Line)
• Battery or power supply problems
• Faulty connectors or terminals
• Interference from other electronic devices

Common Troubleshooting Steps

When dealing with OBD-II code U2251, which indicates a “CAN Bus Communication Failure,” there are several common troubleshooting steps you can take to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Sometimes, multiple codes can provide more context for the issue.
• Inspect the CAN Bus Wiring: **Visual Inspection: Check the wiring and connectors associated with the CAN bus for any visible damage, corrosion, or loose connections.
• **Wiring Integrity: Ensure that the wires are not frayed, pinched, or shorted to ground or power.
• Check the CAN Bus Termination Resistors: The CAN bus requires termination resistors (typically 120 ohms) at each end of the bus. Ensure that these resistors are present and functioning correctly.
• Test the CAN Bus Voltage: Use a multimeter to measure the voltage on the CAN High (CAN H) and CAN Low (CAN L) lines. The typical voltage levels should be around 2.5V when idle, with variations when data is being transmitted.
• Inspect Modules on the CAN Bus: Identify all modules connected to the CAN bus. Check for any modules that may be malfunctioning or have failed, as this can disrupt communication.
• Disconnect each module one at a time to see if the code clears or communication is restored.
• Check for Ground Issues: Ensure that all ground connections related to the CAN bus and the modules are secure and free of corrosion.
• Scan for Module Communication: Use a scan tool to check if you can communicate with all modules on the CAN bus. If some modules are unresponsive, it may indicate a problem with those specific modules.
• Inspect for Interference: Look for any aftermarket devices or modifications that may interfere with the CAN bus communication, such as alarms, stereo systems, or other electronic devices.
• Perform a Network Test: Some advanced scan tools can perform a network test to check the integrity of the CAN bus. This can help identify issues with communication.
• Check for Software Updates: In some cases, a software update for the vehicle’s modules may resolve communication issues. Check with the manufacturer for any available updates.1
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to your vehicle make and model that may address known issues with the CAN bus.1
• Professional Diagnosis: If the issue persists after performing these steps, consider seeking help from a professional mechanic or dealership with experience in diagnosing CAN bus issues.Conclusion Troubleshooting a U2251 code can be complex due to the nature of the CAN bus system. Following these steps methodically can help isolate the problem and lead to a resolution. Always ensure safety precautions are taken when working with vehicle electronics.