U2260 – Lost Communication with the Steering Angle Sensor.

The ODBII code U2260 indicates a loss of communication between the vehicle’s control module and the steering angle sensor, which may affect the vehicle’s stability control and steering functions.

The severity of ODBII code U2260 is moderate.

Common Causes For: U2259 U2259: “Module Communication Failure”

• Faulty steering angle sensor
• Damaged wiring or connectors
• Poor electrical connections
• Malfunctioning power supply to the sensor
• Software issues or calibration errors
• Faulty vehicle control module (VCM)
• Interference from other electronic components

Common misdiagnosis for U2260 Lost Communication with the Steering Angle Sensor.

• Faulty Steering Angle Sensor
• Wiring Issues or Short Circuits
• Faulty Body Control Module (BCM)
• Faulty Electronic Power Steering (EPS) Module
• Incorrectly calibrated steering angle sensor
• Faulty ABS Module
• Issues with the CAN bus communication
• Battery or Power Supply Problems

Common Troubleshooting Steps

When dealing with OBD-II code U2260, which indicates “Lost Communication with the Steering Angle Sensor,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other related trouble codes. This can provide more context and help identify if there are other issues present.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors associated with the steering angle sensor for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or damaged.
• Test the Steering Angle Sensor: **Sensor Functionality: If possible, test the steering angle sensor using a multimeter or scan tool to ensure it is functioning correctly. Check the output voltage or resistance as specified in the vehicle’s service manual.
• **Calibration: Some vehicles require the steering angle sensor to be calibrated after installation or repair. Check if calibration is necessary.
• Check Power and Ground: **Power Supply: Verify that the steering angle sensor is receiving the correct voltage. Use a multimeter to check the power supply at the sensor connector.
• **Ground Connection: Ensure that the ground connection for the sensor is intact and providing a good ground.
• Inspect the CAN Bus: **Communication Lines: Since the steering angle sensor communicates over the CAN bus, check for any issues with the CAN wiring. Look for shorts, opens, or interference in the communication lines.
• **Other Modules: Ensure that other modules on the CAN bus are functioning correctly, as a fault in another module can affect communication.
• Check for Software Updates: **ECU Updates: Check if there are any software updates available for the vehicle’s ECU that may address communication issues or bugs related to the steering angle sensor.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Consult Service Manual: If the issue persists, refer to the vehicle’s service manual for specific diagnostic procedures related to the steering angle sensor and communication issues.
• Professional Diagnosis: If you are unable to resolve the issue after these steps, consider seeking help from a professional mechanic or dealership, as they may have specialized tools and knowledge to diagnose complex issues. By following these steps, you should be able to identify the cause of the U2260 code and take appropriate action to resolve the communication issue with the steering angle sensor.