U2398 – Control Module Communication Bus Fault

The ODBII code U2398 indicates a communication fault in the control module communication bus, suggesting that there is a problem with the data exchange between various control modules in the vehicle.

The severity of ODBII code U2398 is generally considered moderate to severe.

Common Causes For: U2397 Lost Communication with the Steering Angle Sensor.

• Faulty control module
• Damaged wiring or connectors
• Poor ground connections
• Short circuits in the communication bus
• Corroded terminals
• Intermittent electrical connections
• Software issues or bugs in the control module
• Faulty sensors or actuators affecting communication
• Aftermarket modifications or installations interfering with the bus
• Low battery voltage or power supply issues

Common misdiagnosis for U2398 U2398: Control Module Communication Bus Fault

• Faulty control module
• Wiring issues or shorts
• Corrupted software or firmware
• Poor ground connections
• Faulty sensors
• Battery or power supply problems
• Intermittent connection issues
• Other communication bus faults (e.g., CAN bus issues)

Common Troubleshooting Steps

The OBD-II code U2398 indicates a “Control Module Communication Bus Fault.” This code typically points to a problem with the communication between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. Addressing related codes can help pinpoint the issue.
• Inspect Wiring and Connectors: Visually inspect the wiring and connectors associated with the control modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the communication bus wires (CAN bus) for any signs of wear or damage.
• Check for Short Circuits: Use a multimeter to check for short circuits in the communication lines. Ensure that there are no unintended connections between wires.
• Test Control Modules: If possible, test the control modules involved in the communication bus. This may involve checking for proper operation or replacing modules if they are found to be faulty.
• Inspect Ground Connections: Ensure that all ground connections for the control modules are secure and free of corrosion. Poor grounding can lead to communication issues.
• Check for Interference: Look for any aftermarket devices or modifications that may interfere with the communication bus. This includes alarms, stereo systems, or other electronic devices.
• Scan for Communication Issues: Use a professional-grade scan tool to monitor the communication between modules. This can help identify which module is not responding or communicating properly.
• Perform a Hard Reset: Disconnect the vehicle’s battery for a few minutes to reset the control modules. Reconnect and see if the code reappears.
• Update Software/Firmware: Check if there are any software updates available for the vehicle’s control modules. Sometimes, communication issues can be resolved with a software update.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on known issues related to communication faults.1
• Seek Professional Help: If the issue persists after performing the above steps, it may be necessary to consult a professional mechanic or technician who specializes in automotive electronics.Conclusion Troubleshooting a U2398 code can be complex due to the nature of vehicle communication systems. Following these steps systematically can help identify and resolve the underlying issue. Always refer to the vehicle’s service manual for specific guidance related to the make and model you are working on.