U2455 – Control Module Communication Bus Off.

The ODBII code U2455 indicates a communication issue where a control module is unable to communicate over the vehicle’s communication bus, often due to a fault in the module or wiring.

The severity of ODBII code U2455 is moderate to severe.

Common Causes For: U2454 Control Module Communication Bus Off.

• Faulty control module
• Poor electrical connections or wiring issues
• Short circuits in the communication lines
• Corroded connectors
• Faulty or damaged communication bus (CAN bus)
• Software or firmware issues in the control module
• Low battery voltage or power supply issues
• Interference from aftermarket devices or modifications

Common misdiagnosis for U2455 Control Module Communication Bus Off.

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Battery or power supply problems
• Faulty connectors or terminals
• Intermittent communication issues
• Other communication bus errors (e.g., CAN bus issues)

Common Troubleshooting Steps

The OBD-II code U2455 indicates a communication issue between control modules in a vehicle, specifically that a control module is “bus off,” meaning it has stopped communicating on the CAN (Controller Area Network) bus due to a fault. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other related trouble codes. This can provide more context about the issue and help identify which module is having communication problems.
• Inspect Wiring and Connectors: Visually inspect the wiring and connectors associated with the control modules. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the CAN bus wiring, which typically consists of a twisted pair of wires.
• Check for Short Circuits or Open Circuits: Use a multimeter to check for continuity in the CAN bus wiring. Look for any short circuits or open circuits that could disrupt communication.
• Test the Control Modules: If you suspect a specific control module is causing the issue, you can test it by swapping it with a known good module (if available) or using a diagnostic tool to check its functionality.
• Inspect Ground Connections: Ensure that all ground connections for the control modules are secure and free of corrosion. Poor grounding can lead to communication issues.
• Check for Power Supply Issues: Verify that the control modules are receiving the correct voltage. Use a multimeter to check the power supply to the affected modules.
• Look for Interference: Check for any aftermarket devices or modifications that may be interfering with the CAN bus communication. This includes things like alarm systems, stereo systems, or other electronic accessories.
• Perform a Network Test: Some advanced diagnostic tools can perform a network test to check the integrity of the CAN bus. This can help identify if there are any issues with the bus itself.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Technical Service Bulletins (TSBs): Check for any manufacturer-specific TSBs related to the U2455 code or communication issues. There may be known fixes or recalls that apply to your vehicle.1
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who has experience with automotive electronics and communication systems. By following these troubleshooting steps, you can systematically identify and resolve the underlying issue causing the U2455 code.