U2572 – Control Module Communication Bus Fault

The ODBII code U2572: Control Module Communication Bus Fault indicates a problem with the communication between control modules in a vehicle, suggesting that one or more modules are not properly exchanging data over the communication bus.

The severity of ODBII code U2572 is generally considered moderate.

Common Causes For: U2570 U2570: Control Module Communication Bus Fault

• Faulty control module
• Damaged wiring or connectors
• Poor ground connections
• Short circuits in the communication bus
• Corroded connectors
• Intermittent electrical connections
• Software issues or bugs in the control module
• Faulty or incompatible aftermarket parts
• Low battery voltage or power supply issues
• Environmental factors (moisture, heat, etc.) affecting connections

Common misdiagnosis for U2572 U2572: Control Module Communication Bus Fault

• Faulty control module
• Wiring issues or damaged connectors
• Battery or power supply problems
• Software or firmware issues
• Grounding problems
• Intermittent communication faults
• Other unrelated sensor failures

Common Troubleshooting Steps

The OBD-II code U2572 indicates a “Control Module Communication Bus Fault.” This code typically points to a communication issue between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other related trouble codes. Sometimes, multiple codes can provide more context about the issue.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harnesses and connectors associated with the control modules for any signs of damage, corrosion, or loose connections.
• **Repair or Replace: If any damaged wires or connectors are found, repair or replace them as necessary.
• Check for Short Circuits: Use a multimeter to check for short circuits in the communication lines. Ensure that the wires are not shorted to ground or to each other.
• Verify Power and Ground: Ensure that the control modules have the proper power supply and ground connections. Use a multimeter to check voltage and ground continuity.
• Inspect the CAN Bus: If your vehicle uses a Controller Area Network (CAN) bus, check the CAN bus lines for continuity and resistance. The typical resistance should be around 60 ohms between the CAN High and CAN Low lines.
• Look for any interruptions or faults in the CAN bus wiring.
• Check for Module Functionality: If possible, test the functionality of the control modules involved. This may involve using specialized diagnostic tools or software to communicate with the modules.
• If a specific module is not responding, it may need to be replaced.
• Clear Codes and Test Drive: After performing any repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code returns.
• Check for Software Updates: Sometimes, communication issues can be resolved with a software update. Check with the vehicle manufacturer for any available updates for the control modules.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U2572 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues.
• Seek Professional Help: If the issue persists after performing the above steps, it may be necessary to consult a professional mechanic or technician who has experience with your vehicle’s specific systems. By following these troubleshooting steps, you should be able to identify and resolve the underlying issue causing the U2572 code.