U2587 – Communication Bus Off.

The ODBII code U2587 indicates a communication issue where a module on the vehicle’s communication bus has gone offline or is not responding, potentially due to a fault in the wiring, a malfunctioning module, or a loss of power.

The severity of ODBII code U2587 Communication Bus Off is moderate to severe.

Common Causes For: U2585 Lost Communication with the Steering Angle Sensor.

• Faulty wiring or connectors in the communication bus.
• Malfunctioning control modules.
• Short circuits or open circuits in the communication lines.
• Corrupted software or firmware in the control modules.
• Electrical interference from other components.
• Low battery voltage or poor power supply to modules.
• Faulty or damaged sensors connected to the bus.

Common misdiagnosis for U2587 Communication Bus Off.

• Faulty ABS module
• Defective body control module (BCM)
• Malfunctioning engine control module (ECM)
• Wiring issues or shorts in the communication lines
• Faulty sensors or actuators
• Power supply issues
• Incorrectly diagnosed transmission problems
• Issues with the instrument cluster

Common Troubleshooting Steps

The OBD-II code U2587 indicates a communication issue related to the vehicle’s communication bus, specifically that a module is reporting a “Bus Off” condition. This typically means that the module is unable to communicate properly over the CAN (Controller Area Network) bus. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Other Codes: Use an OBD-II scanner to check for any other diagnostic trouble codes (DTCs) that may be present. Other codes can provide additional context for the problem.
• Inspect Wiring and Connectors:
• Visually inspect the wiring and connectors associated with the affected module and the CAN bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication issues.
• Check the Module:
• Identify the specific module that is reporting the U2587 code. This could be a body control module, engine control module, or another electronic control unit (ECU).
• If possible, test the module for proper operation. This may involve checking for power and ground at the module, as well as verifying that it is functioning correctly.
• Test the CAN Bus:
• Use a multimeter or an oscilloscope to check the voltage levels on the CAN bus wires (typically CAN High and CAN Low). The voltage levels should be within the specified range for proper communication.
• Look for any short circuits or open circuits in the CAN bus wiring.
• Check for Interference:
• Ensure that there are no devices or components that could be causing interference on the CAN bus. This includes aftermarket accessories or modifications that may affect the communication.
• Perform a Network Test:
• If you have access to a professional scan tool, perform a network test to see if other modules on the CAN bus are communicating properly. This can help identify if the issue is isolated to one module or if it affects multiple modules.
• Clear Codes and Test Drive:
• After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Replace Faulty Components:
• If a specific module is determined to be faulty after testing, consider replacing it. Ensure that any replacement module is properly programmed and configured for your vehicle.
• Consult Technical Service Bulletins (TSBs):
• Check for any TSBs related to the U2587 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues that can assist in troubleshooting.
• Seek Professional Help:
• If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or automotive technician who has experience with CAN bus systems and advanced diagnostic tools. By following these steps, you should be able to identify and resolve the underlying issue causing the U2587 code.