U2607 – CAN Bus Communication Failure

The ODBII code U2607: CAN Bus Communication Failure indicates a malfunction in the Controller Area Network (CAN) communication system, which may affect the communication between various vehicle modules.

The severity of ODBII code U2607: CAN Bus Communication Failure is generally considered moderate to severe.

Common Causes For: U2605 Invalid Data Received from Vehicle Dynamics Control Module.

• Faulty CAN bus wiring or connectors
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Faulty control module
• Poor ground connection
• Interference from other electronic devices
• Corroded or damaged connectors
• Software issues or bugs in the control module
• Low battery voltage or power supply issues
• Faulty termination resistors

Common misdiagnosis for U2607 U2607: CAN Bus Communication Failure

• Faulty Engine Control Module (ECM)
• Defective Body Control Module (BCM)
• Bad wiring or connectors
• Faulty CAN Bus transceiver
• Malfunctioning sensors
• Power supply issues
• Grounding problems
• Software glitches or updates needed
• Other communication network failures
• Faulty diagnostic tools or equipment

Common Troubleshooting Steps

The OBD-II code U2607 indicates a CAN (Controller Area Network) bus communication failure. This code typically points to issues with the communication between various modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve the U2607 code:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context or indicate which module is having issues.
• Inspect the CAN Bus Wiring: Visually inspect the wiring and connectors associated with the CAN bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the wiring harnesses that connect the various modules.
• Check for Short Circuits or Open Circuits: Use a multimeter to check for continuity in the CAN bus wiring. Look for any short circuits or open circuits that could disrupt communication.
• Test the CAN Bus Voltage: Measure the voltage on the CAN High and CAN Low wires. The typical voltage levels should be around 2.5V when idle and should vary when data is being transmitted.
• If the voltage levels are outside the expected range, there may be a fault in the wiring or a module.
• Inspect Modules: Identify the modules connected to the CAN bus. Check for any signs of damage or malfunction in these modules.
• If possible, disconnect and reconnect the modules to ensure good connections.
• Check for Ground Issues: Ensure that all modules have a good ground connection. A poor ground can lead to communication failures.
• Scan for Module Communication: Use a scan tool to check if you can communicate with all modules on the CAN bus. If some modules are unresponsive, they may be the source of the problem.
• Look for Environmental Factors: Check for any environmental factors that could affect the CAN bus, such as water intrusion or exposure to extreme temperatures.
• Perform a Network Test: If available, use a professional-grade scan tool to perform a network test. This can help identify which module is causing the communication failure.
• Replace Faulty Components: If a specific module is identified as faulty, consider replacing it. If wiring issues are found, repair or replace the damaged wiring.1
• Clear Codes and Test Drive: After making repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.1
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the U2607 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues.1
• Seek Professional Help: If the issue persists after following these steps, consider seeking help from a professional mechanic or automotive technician who has experience with CAN bus systems. By following these troubleshooting steps, you can systematically identify and resolve the underlying issues causing the U2607 code.