U2608 – CAN Bus Communication Failure

The ODBII code U2608 indicates a “CAN Bus Communication Failure,” meaning there is a problem with the communication between the vehicle’s control modules over the Controller Area Network (CAN) bus.

The severity of ODBII code U2608 is moderate to severe.

Common Causes For: U2607 U2607: CAN Bus Communication Failure

• Faulty CAN bus wiring or connectors
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Faulty ECU (Electronic Control Unit)
• Malfunctioning sensors or modules on the CAN bus
• Poor ground connections
• Interference from other electronic devices
• Corroded or damaged connectors
• Software issues or bugs in the ECU
• Low battery voltage or power supply issues

Common misdiagnosis for U2608 U2608: “CAN Bus Communication Failure”

• Faulty CAN Bus wiring
• Defective ECU (Engine Control Unit)
• Malfunctioning sensors
• Poor ground connections
• Faulty connectors or terminals
• Issues with other communication modules
• Software glitches or outdated firmware
• Battery or power supply problems
• Interference from aftermarket devices
• Corroded or damaged pins in connectors

Common Troubleshooting Steps

The OBD-II code U2608 indicates a “CAN Bus Communication Failure.” This code typically points to issues with the Controller Area Network (CAN) bus, which is responsible for communication between various electronic control units (ECUs) in a vehicle. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other related trouble codes. This can provide more context about the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Look for damaged, frayed, or corroded wires and connectors related to the CAN bus.
• **Loose Connections: Ensure that all connectors are securely attached and free of corrosion.
• Test the CAN Bus Voltage: Use a multimeter to check the voltage levels on the CAN High (CAN H) and CAN Low (CAN L) wires. The typical voltage levels should be around 2.5V when idle and should vary when data is being transmitted.
• Check for Short Circuits: Inspect the CAN bus wiring for any short circuits to ground or to each other. This can cause communication failures.
• Inspect the ECUs: Check the individual ECUs connected to the CAN bus. A malfunctioning ECU can disrupt communication. If possible, test the ECUs individually or replace suspected faulty units.
• Look for Interference: Ensure that there are no aftermarket devices or modifications that could be interfering with the CAN bus communication.
• Check for Software Issues: Sometimes, a software update or reprogramming of the ECUs may be necessary. Check with the manufacturer for any available updates.
• Perform a Network Test: Use a professional scan tool capable of performing a CAN bus network test to identify any communication issues between the ECUs.
• Inspect the Termination Resistors: Ensure that the CAN bus has the correct termination resistors (typically 120 ohms) at both ends of the bus. Missing or faulty resistors can lead to communication failures.
• Clear Codes and Test Drive: After performing repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.1
• Consult a Professional: If the issue persists after performing these steps, it may be best to consult a professional mechanic or technician who specializes in automotive electronics. By following these troubleshooting steps, you can systematically identify and resolve the underlying issues causing the U2608 code.