U2613 – Lost Communication with the Steering Angle Sensor.

The ODBII code U2613 indicates a loss of communication between the vehicle’s control module and the steering angle sensor, which may affect the vehicle’s stability control and steering functions.

The severity of ODBII code U2613 is generally considered moderate.

Common Causes For: U2611 CAN Communication Bus Off.

• Faulty steering angle sensor
• Damaged wiring or connectors
• Poor electrical connections
• Malfunctioning power supply to the sensor
• Software issues or calibration errors
• Faulty vehicle control module (VCM)
• Interference from other electronic components

Common misdiagnosis for U2613 Lost Communication with the Steering Angle Sensor.

• Faulty steering angle sensor
• Wiring issues or damaged connectors
• Faulty steering column module
• Malfunctioning ABS module
• Incorrectly calibrated steering angle sensor
• Power supply issues
• Faulty vehicle stability control system
• Software or firmware issues in the vehicle’s control modules

Common Troubleshooting Steps

When dealing with the OBD-II code U2613, which indicates “Lost Communication with the Steering Angle Sensor,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context or indicate related issues.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors associated with the steering angle sensor for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or pushed back.
• Test the Steering Angle Sensor: **Sensor Functionality: If possible, test the steering angle sensor using a multimeter or scan tool to ensure it is functioning correctly. Check for proper voltage and signal output.
• **Calibration: Some vehicles require the steering angle sensor to be calibrated after installation or repair. Refer to the vehicle’s service manual for calibration procedures.
• Check Power and Ground: **Power Supply: Verify that the steering angle sensor is receiving the correct voltage. Use a multimeter to check the power supply at the sensor connector.
• **Ground Connection: Ensure that the ground connection for the sensor is intact and has a good connection.
• Inspect the CAN Bus: **Communication Lines: Since the steering angle sensor communicates over the CAN bus, check for any issues with the CAN wiring. Look for shorts, opens, or interference.
• **CAN Bus Termination: Ensure that the CAN bus is properly terminated at both ends.
• Check for Software Issues: **ECU Updates: Sometimes, software updates for the vehicle’s ECU can resolve communication issues. Check with the manufacturer for any available updates.
• **Resetting the ECU: Disconnect the battery for a few minutes to reset the ECU, then reconnect and see if the code returns.
• Test Other Related Components: If the steering angle sensor is part of a larger system (like stability control or power steering), check other components in that system for faults.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the steering angle sensor or communication issues for your specific vehicle make and model. Manufacturers may have known fixes for common problems.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose the problem more effectively.Conclusion By following these troubleshooting steps, you can systematically identify and address the cause of the U2613 code. Always refer to the specific service manual for your vehicle for detailed procedures and specifications.